Episode HT Series User manual

Episode HTSeries
Welcome to the documentation page for Episode HTin-room speakers.
Use the navigation to access our various installation guides.
Pro Tip: -_These docs get updated from time to time based on your feedback. To ensure you have
the latest version, either clear your cache, or open this in a new incognito/privacy tab.
Build 230414
1

Install the HT-IRATM
Box Contents
Your box should contain:
lspeaker
l2 × grilles
l2 × screws
l4 × small feet
l4 × large feet
l2 × mounting pins
lmounting bracket
lmounting pad
llocking bar
Ensure your mounting surface is able to hold three times the weight of the speaker.
2

Attach the grilles
Place the magnetic grilles over the speakers for protection during the install.
3

Select the speaker mode
Flip the switch to designate whether the speaker is aimed at a wall or ceiling ("Reflected," right), or
is aimed at the audience ("Directed," left).
4

Attach the wires
Run the wires beneath the stress relief bar as shown, and connect them to the speaker terminals.
If your wires already have banana clips attached, you can loosen the screws holding the stress
relief bar.
5

For standing installs...
If you are installing this on a flat place like a bookshelf or on top of a floor-standing speaker, attach
the four small adhesive feet. Set the speaker in place, and you're done!
Otherwise, continue.
6

Attach the mounting pins
Insert the mounting pins into the mounting pad.
7

Attach the large feet
Attach the four large feet to the speaker to insulate it from the mounting surface.
8

Secure the pad to the speaker
Use the screws provided to secure the mounting base to the speaker body as shown.
9

Attach the bracket
Attach the bracket to the mounting surface. Note that the keyholes are angled; be sure to use the
guides etched into the bracket for proper centering.
10