EPOS FlashExtractor Use and care manual

1
EPOS FlashExtractor
Firmware update manual
The firmware update of the EPOS FlashExtractor is supported in devices, produced
after May 1 2013 and equipped with an additional USB Update Adapter.
USB Update Adapter EPOS FlashExtractor with the adapter
The current firmware version is available at the device’s page at the manufacturer’s
site (www.epos.ua, section "Our solutions").
There you can also get the firmware update utility (PIC24H User Programmator.exe)
and the driver for the USB Update Adapter (FTDI VCP Driver).
Firmware update process:
1. Turn the device off (if it was on);
2. Start the firmware update utility "PIC 24H User Programmator";
Note: If the firmware update utility is started after the device is turned on, the
update will be impossible.

2
3. Connect the USB Update Adapter to the device and then connect it to a PC via USB
cable;
4. Turn the device on and wait for the diagnostic message "Devices setup
completed" (Установка устройств завершена). The device information should
appear in the program window;
5. Select a device for updating (flag the corresponding field "Type dev");
6. Press the button "Load File" and specify the path to the firmware file on the PC;
7. Press the button "Program device";

3
8. Completion of the firmware update (programming) is indicated by the progress bar
and a corresponding diagnostic message (Отключите питание устройства,
отключите кабель USB и включите питание устройства). After that, it is
necessary to close the firmware update utility, turn the device off and disconnect
the USB cable.
Firmware update is finished. The device is ready for further use.