Bartec TC 7 Series User manual

Datei: en_userguide_bartec_tc7x_scanhandle.docx - Datum: 16.03.2020
1
Product Information USER GUIDE
SCAN HANDLE
FOR EX-APPROVED TOUCH COMPUTER
TC 7x SERIES
© BARTEC GmbH 2019 –Subject to changes and amendments, errors expected
1
3
5
1. INSERTION
1. Take the TC7x and put it into the left holder
of the handle.
2. Align the lower left side of the handle
holder to the edge of the black TC7x
rubber.
3. Now push the right side of the TC7x down
and
4. move the handle a little bit forward until
the lock catches snap into the holes at the
TC7x battery release buttons.
5. Then push the right holder of the handle
until it snaps over the right side of the
TC7x. Ready!
If the TC7x Scan Handle is mounted in the
correct position you will hear a gently
“click” when pressing the scan button.
2. Align
4. Move till snap
5.Push
“click”
Note: The Scan
Handle is
designed to carry
the TC7x with
mounted
handstrap.
For easy
insertion please
put the
handstrap in a
flat position

Datei: en_userguide_bartec_tc7x_scanhandle.docx - Datum: 16.03.2020
2
Product Information USER GUIDE
SCAN HANDLE
FOR EX-APPROVED TOUCH COMPUTER
TC 7x SERIES
© BARTEC GmbH 2019 –Subject to changes and amendments, errors expected
2. REMOVAL
Push the right holder of the handle until it moves above the right side
of the TC7x. Turn the TC7x out of the handle.
3. PTT-BUTTON REMAPPING
The Scan Handle uses the PTT-
Button to trigger the scanner.
Please remap the PTT-Button
with the following instructions:
1. Start Settings->Key
Programmer
2. Click on button with key
event “LEFT_TRIGGER_2”,
default setting is “BUTTON_L2”
3. Select “BUTTON_L1”
4. Ready, screenshot on the
right shows the remapped
“LEFT_TRIGGER_2” on event
“BUTTON_L1” for Scan Handle
usage
4. STYLUS MOUNTING
For easy access to the
TC7x stylus the Scan
Handle provides a
holder for the stylus
and a hole to mount
the stylus cord. The
picture shows the
Scan Handle with
mounted stylus.
5.CARE
Do not use oil to lubricate
the mechanism. Oil
detracts plasticizers from
the material, the plastic
parts become brittle.
Do not use harsh chemicals,
cleaning solvents or strong
detergents to clean the Scan
Handle. Clean the Scan
Handle with a damp cloth.