Equustek DL4500-EDH+ User manual

#815-1200 W73rd Ave, Vancouver, BC, V6P6G5, Canada Phone: [phone] or 604-266-8547 www.equustek.com
DL4500-EDH+/EDH-485 RSLINX Quick Start
This document assumes that the DL4500-EDH+/EDH-485 (now referred to as DL4500)
hardware has been installed and configured as referred to in the DL4500-EDH+/EDH-
485 Hardware Quick Start document.
This quick start is to help you get started with your DL4500 using RSLINX.
1. Start RSLINX
2. Select Configure Drivers
3. Choose RS-232 DF1 Devices from the Available Driver Types
4. Click on Add New
5. Type in a name for the driver or use the default
6. Click OK

#815-1200 W73rd Ave, Vancouver, BC, V6P6G5, Canada Phone: [phone] or 604-266-8547 www.equustek.com
7. Select the Comm Port that has been configured in your Redirector
software as the Virtual Com Port for the IP address of the DL4500.
8. Select 1770-KF2 device for the DL4500-EDH+ or
1770-KF3 for the DL4500-EDH-485

#815-1200 W73rd Ave, Vancouver, BC, V6P6G5, Canada Phone: [phone] or 604-266-8547 www.equustek.com
9. Set the station number to the last octet of the IP address (Use the
following Mapping table for the IP address to DH+/DH-485 Node
number.
DH+ Node Table
DH-485 Node Table
10.Set the Baud Rate to match the setting used in the Ethernet
configuration of the DL4500.
11.Ensure Parity None, 1 Stop Bit, BCC Error Checking, and Full
Duplex Protocol
12.Click OK.
The RSLINX Driver is now configured. RSWHO should show all the nodes
on your DH+ or DH-485 network.
Node Address Last Octet of IP address
0-63 0-63
0-63 64-127
0-63 128-191
0-63 192-255
Node Address Last Octet of IP address
0-31 0-31
0-31 32-63
0-31 64-95
0-31 96-127
0-31 128-161
0-31 162-191
0-31 192-223
0-31 224-255