ERA 330503 Use and care manual

Technical bulletin n°5 November 17
th
, 2018
INTRODUCTION
Shown below, you can find the procedure that you must follow to replace brake light switches.
This procedure is available for ERA code 33 5 3, 33 544, 33 545, 33 597, 33 7 6, 33 734,
33 797, 33 815, 33 934, 33 935, 33 936, 33 937, 33 94 , 33 941 e 33 977.
INSTALLATION INSTRUCTION
Steps to follow:
1)
Unplug the connector from the Brake Light Switch.
Remove the old switch. It has to be turned in Counter
Clock Wise sense (approx. 45 º).
BRAKE LIGHT SWITCH REPLACEMENT
PROCEDURE

Technical bulletin n°5 November 17
th
, 2018
2)
T
ake the new
s
witch
(ERA code
33 5 3
)
.
ATTENTION: The switch can be tested electrically
exclusively when it is totally assembled, since it is
supplied in the “deactivated position“.
Insert the new Switch inside the hole of the pedal
body (it has only one possible position). To fix it
correctly the body has to be turned in Clock Wise
sense, until the click (approx. 45°)
3)
After
the assembly
, the switch is “activated” and it
can be tested electrically.