Errebi Q-UICK User manual

Q-UICK
Errebi Remote Controls for duplicating quartz
remote controls.
— Duplicate xed codes.
— Frequencies 25 to 41 MHz.
— 4 remote controls in 1. Duplicate four remote
controls on a single ERREBI remote control.
— Copies the code and the frequency by proxi-
mity.
— Optional connection with a PC to work with
ERREBIRemotesPro software.
Q-UICK REMOTE CONTROL
YOUR KEY
www.errebispa.com
MULTI-FUNCTIONAL PC
SOFTWARE
ERREBIREMOTESPRO
A SINGLE
REMOTE CONTROL
FOR ALL FRQUENCIES
WITHOUT HAVING TO CHANGE
THE QUARTZ CRYSTAL
CLONE QUARTZ REMOTE CONTROLS
WITHOUT REQUIRING A CRYSTAL

ERREBI S.p.A. Unipersonale, Via Pianezze 42-49-32040 Cibiana di Cadore (BL) - Italy-tel.[phone] - fax [phone] - [email protected] - www.errebispa.com
REMOTE CONTROL
Q-UICK
DUPLICATING SEQUENCE
Press buttons 1 and 2 of the remote
control copy simultaneously until the led
ashes red. Release both buttons and
wait for led red to turn off.
Press the button on the original remote
control you wish to copy.
Hold the button until the LED on the new
remote control ashes red.
Open the remote and locate the trimmer
and the adjustment button.
At the optimum power stage the green
light will turn on and the remote will be
adjusted.
At the same time, press the adjustment
button and move the trimmer with a
screwdriver to adjust the power. The red
led will light up and blink faster as you are
reaching the right amount of power.
When the LED turns off,
the copy is completed.
When the LED is off, press the button
onto which you wish to make the copy.
The LED will light up red.
Hold the original remote control against
the new one.
Once the copy is complete, the Q-UICK remote control’s power should be adjusted.
The Q-UICK remote control can operate within the 25 to 41 MHz frequency range. To adjust the power follow the next steps:
1
4
6 87
5
2 3
YOUR KEY
www.errebispa.com
ADJUSTMENT BUTTONTRIMMER