ESC ELMARK ELFS10 User manual
PO BOX 816, Hamilton 3240
4-8 Mainstreet Place
Hamilton 3200
+64 7 849 9119
0800 350 000
+64 7 849 9119
0800 350 000
INSTRUCTION FOR FLOAT SWITCH
CONTROL OF ELECTRICAL PUMP
ESC CODE: ELFS10
PO BOX 816, Hamilton 3240
4-8 Mainstreet Place
Hamilton 3200
+64 7 849 9119
0800 350 000
IMPORTANT
The device connected to an electrical pump through an electrical
cable is used for the auto-control and no water protection of the
water tower and water tanks
SPECIFICATIONS
INSTALLATION
Rated Voltage 125V / 250V AC
Max. Current 16 (4) A
Frequency 50 - 60Hz
Max. Operating Temperature 50ºC
Protection Grade IP68
Conforms To IEC 60730-1:2000
1. Fix the counterweight on the power cable to control water level.
2. Connect the electrical cable with the electrical pump and then fix it inside the water tank.
3. The length of the cable section between the fixation point of the device and the device
body determines the water level.
4. The terminal of the electrical cable shall never be immersed into water during installation.
WARNINGWARRANTY
1. The power supply cable is an integrate part of the device. Should the cable be found to
be damaged the device is to be replaced. Repairs to the cable itself are not possible.
2. The cable terminal must be never immersed into water.
3. The cable that is not used must be correctly insulated.
4. The electrical pump must be grounded to avoid any accidents.
The warranty period for this product is 12 months from date of purchase. Any defects caused
by mal-manufacture, the user can return the device to the stocklist for repair or replacement.
Warranty does not apply to any defects caused by misuse and improper storage.
PO BOX 816, Hamilton 3240
4-8 Mainstreet Place
Hamilton 3200
+64 7 849 9119
0800 350 000
+64 7 849 9119
0800 350 000
INSTRUCTION FOR USAGE
Instruction for water-filling operation:
Fig 1
Fig 4
Fig 2
Fig 5
Fig 3
Fig 6
Fig 7
Connect the black cable of the floating control to the line phase connection and the blue
wire to the electrical pump as shown in Fig.1 for water filling operation (The brown cable
shall be kept insulated). For detailed installation instruction,please refer to Fig.2 and 3.
Function of Fig2 & 3.Electrical pump begins to fill water when the water in water tank drops
to a certain level and stops its working when water rises to certain level.
Connect the black cable of the floating control to the line phase connection, the blue to the
auto fill pump and the brown to the auto empty pump as shown in Fig.1 and 4. For detailed
instruction refer to Fig. 7.
Function of Fig.5 & 6: Electrical pump stops when the water level in the water pool drops to
a certain level and starts to emptying water again when the water level increases.
Fig. 7:shows the auto-switch between filling
and emptying water, which is an extension
of the two basic functions.
Please refer to the two basic functions for
details.
AUTO FILLING & AUTO EMPTYING
PO BOX 816, Hamilton 3240
4-8 Mainstreet Place
Hamilton 3200
+64 7 849 9119
0800 350 000
Fig.8:Peel the plastic ring off the
counterweight before installation and
set thering around the cable, then insert
the cable from the conic part into the
counterweight and fix it with moderate
pressure at the fixing end.
COUNTERWEIGHT INSTALLATION
Fig 8
Table of contents
