Essentials B3010 User manual

AB
DE F
Included in box:
B3010 Shower Bench
Feb 2019, Essential Medical Supply, Inc.
x 4
x 5
x 2
Adjustable LegArmrest
Seat PanelFrame Tubing (A)
Wave Washers
Wing Knob Screws
G
Frame Tubing (B)
C
WARNING:
• Before using, be sure that all gold locking buttons fully protrude thru holes of each
Adjustable Leg (G).
• Make sure all Adjustable Legs are snapped in the same hole position (G).
• Periodically retighten all Wing Knob screws on the bottom of the seat.
ATTENTION:
USER WEIGHT LIMIT: 300lbs.
• Pleaseverifythatallcomponentsareincludedasshownabove,
beforeproceedingwithassembly.
• DONOTUSEASAVANITYSTOOL
California Proposition 65
WARNING: Cancer & Reproductive Harm
www.P65Warnings.ca.gov

2Identify the difference between the upper and lower
Frame Tubing pieces (A & B). Both of the pieces have
stickers to identify them. One Frame Tubing piece is
labeled “A” and the other is labeled “B”.
1Place the Seat Panel (C) upside down on a at
surface with the triangle indent facing upwards. This
triangle indicates the front of the Seat Panel (C).
4Place lower Frame Tubing piece “B” in the indent
labeled “B” with the legs facing upwards crossing
over upper Frame Tubing piece “A”.
3Place upper Frame Tubing piece “A” in the indent
labeled “A”, with the legs facing upwards.
5Take one of the Wing Knob Screws (F) and Wave
Washers (G) and place the Wave Washer (G), with
arc facing down, onto the Wing Knob Screw (F).
Insert the Wing Knob Screw (F) into the hole where
the two Frame Tubing pieces (A & B) overlap. Hand
tighten the Wing Knob Screw (F) while making sure
the Wave Washer (G) aligns with the tubing.
6Take the four remaining Wing Knob Screws (F) and
Wave Washers (G) and place in the four remaining
holes as in Step 5. Hand tighten Wing Knob
Screws (F).
A
B
x 1 x 4
Front
Upper Frame
Lower Frame
A
B
A
A
B
A
B
A
B
A
B
A
B
A
B
A
B

9Examine both Armrests (D) and identify the
brass buttons. 11 Now that the chair is completely assembled,
ensure all of the Wing Knob Screws (F) are hand
tight and Wave Washers (G) are aligned with their
respective tubing.
8Flip chair over and verify all Adjustable Legs (E)
are touching the oor. Make sure the chair is level
and stable.
7Identify the brass buttons on the four posts of the
Frame Tubing (A & B). Take one of the Adjustable
Legs (E), and while pressing in the button, slide
the Adjustable Leg (E) over the post until the brass
button protrudes. Adjust height accordingly and
repeat with remaining Adjustable Legs (E).
10 Press the brass buttons in while sliding the Armrest
(D) into the frame silencers. Make sure the buttons
protrude from the holes in the Frame Tubing (A & B).
Repeat with second Armrest (D).
WARNING:
• Before using, be sure that all gold locking buttons
fully protrude thru holes of each Adjustable Leg (E).
• Make sure all Adjustable Legs (E) are snapped in
the same hole position.
• Periodically retighten all Wing Knob screws on the
bottom of the seat.
x 4
x 2