Tendercare MINI TILT User manual

Mini Tilt Wheelchair User Manual v2
Authority. Quality Controller
Authorised. J Adams November 05
+
U
US SE ER RM MA AN NU UA AL L
F
Fo or r
M
MI IN NI IT TI IL LT TW WH HE EE EL LC CH HA AI IR R
IMPORTANT
Please read these instructions carefully
Before using your wheelchair

Mini Tilt Wheelchair User Manual v2
Authority. Quality Controller
Authorised by, J Adams
Page 2 of 15
November 05
Headrest
Push
Handle
Tipping
Lever
Brake
Lever
Footrest
Armrest
T
TE EN ND DE ER RC CA AR RE E
MINI TILT WHEELCHAIR
Backrest
Lock
Gas Strut
Operating Lever

Tendercare Ltd
Mini Tilt Wheelchair User Manual
Mini Tilt Wheelchair User Manual v2
Authority. Quality Controller
Authorised by, J Adams
Page 3 of 15
November 05
CONTENTS
ITEM DESCRIPTION PAGE
1Who to contact if you have difficulty………………………………. 4
2Intended user………………………………………………………… 4
3Unpacking……………………………………………………………. 4
4Preparing for use…………………………………………………….. 5
4.1 Unfolding and assembling the wheelchair……………………….. 5
4.2 Adjusting the footrests…………………………………………… 6
4.3 Fitting and removing headrest……………………………………. 7
4.4 Tilt in Space……………………………………………………… 8
4.5 Tyres and Brakes…………………………………………………. 8
4.6 Rear Wheel Position……………………………………………… 9
4.7 Tipping the Wheelchair………….………………………………. 10
5User instructions…………………………………………………….. 10
5.1 Getting into the wheelchair………………………………………. 10
5.2 Getting out of the wheelchair…………………………………….. 10
5.3 Sideways transfer………………………………………………… 10
6Attendant Pushing…………………………………………………… 11
6.1 Pushing…………………………………………………………… 11
6.2 Brakes…………………………………………………………….. 11
6.3 Comfort…………………………………………………………... 12
6.4 Lifting and general safety………………………………………... 12
7Cleaning……………………………………………………………… 12
8Maintenance…………………………………………………………. 12
8.1 Routine maintenance…………………………………………….. 12
8.2 Six monthly maintenance………………………………………… 13
9Warranty……………………………………………………………... 13
10 Transporting the wheelchair………………………………………... 13
11 Repairs……………………………………………………………….. 15

Tendercare Ltd
Mini Tilt Wheelchair User Manual
Mini Tilt Wheelchair User Manual v2
Authority. Quality Controller
Authorised by, J Adams
Page 4 of 15
November 05
1. Who to contact in difficulty
Tendercare Ltd
PO Box 3091, Littlehampton, BN16 2WF
Tel [phone] Fax [phone]
Email: [email protected]
2. Intended user
This product benefits from a tilt in space facility and has been designed for use as a
wheelchair or wheelbase for use with special seating systems. It is available in three seat
widths 305mm (12”), 356mm (14”) and 406mm (16”). These instructions apply to all sizes.
The wheelchair has four wheels the front wheels are castors to allow easy steering. The
backrest can be folded for transit. The armrests lift off for easy side transfer and the push
handles are adjustable in height to suit a wide range of attendants.
The maximum carrying weight including the user and all accessories should not exceed 102kg
(16 stone).
3. Unpacking
The wheelchair is delivered in a cardboard carton approximate weight 23 kg and size 700 mm
wide x 570 mm deep x 950 mm high.
Warning the transit carton is heavy so moving and unpacking must be done with care.
Observe all lifting and handling regulations.
1) Stand the Carton upright making sure it is supported and cannot fall over. Open the
carton and remove any packages or packing, which could obstruct the removal of the
frame.
2) Carefully pull out the wheelchair and check that you have the following items:-
Item Component Number Yes No
1. Mini Tilt wheelchair 1
2. Armrests 2
3. Push handles 2
4. Thumb screws (for push handles) 4
5. Footrests 2
6. User Manual 1
If any items are damaged or missing please contact Tendercare,
Preferably by fax [phone] within 36 hours of delivery.
3) After unpacking and checking you have all components and that they are in good
condition, carefully dispose of the packaging at your local recycling centre.

Tendercare Ltd
Mini Tilt Wheelchair User Manual
Mini Tilt Wheelchair User Manual v2
Authority. Quality Controller
Authorised by, J Adams
Page 5 of 15
November 05
4. Preparing for use and operation
Warning: - when assembling the wheelchair for use, ensure that you hold the frame so
that you avoid any danger of catching your fingers in moving parts.
4.1 Assembling the wheelchair
1) Carefully lift the wheelchair upright.
2) Backrest supports.
Standing behind the wheelchair lift the two-backrest locking
pins using the ball shaped handgrips at the bottom of the
backrest tubes. Turn them so that they lock into the groove
arrowed opposite.
Lift backrest supports vertical.
Lock the supports in position by moving the handgrips out of
the arrowed groove (see photo) and make sure they move to the
bottom of the slot in the backrest tube.
3) Push handles.
The height of the push handles can be adjusted to suit the needs of a
large range of attendants.
To adjust the height to suit you, simply loosen (turn anti clockwise)
the two thumbscrews at either side and near the top of the backrest.
(See photo opposite). Lift or lower the push handles to a height that
suits you then retighten (turn clockwise) the thumbscrews.
Tip: - To prevent the push handles moving in use these screws must
be tight. You should regularly check that they are tightened
properly.