Eva-Dry EDV-1100 User manual

1
EDV-1100 Electric
Petite Dehumidier
User Manual
on
full
Whisper Technology

2

3
In order to keep noise emissions at their lowest levels, The Petite Dehumidier uses Whis-
per Technology. Whisper Technology dehumidies air without the use of a compressor,
which makes The Petite Dehumidier quiet, light and portable. The Petite Dehumidier
is perfect for any small room, closet, or crawl space. Poor ventilation can cause unwant-
ed odors and fungus to occur throughout the home. The Petite Dehumidier tackles this
problem by removing excess moisture from the air and storing it in an attached water tank,
which can be easily removed and emptied by the user.
Overview
1. On/O Button
2. “On” Green LED indicator
3. “Full” Yellow LED indicator
4. Air Inlet
5. Removable Water Tank
6. Dry Air Outlet
7. DC Power Socket
8. Rubber Feet
9. AC/DC Power Adapter
10. DC Power Jack
11. AC Connector
12. Water Displacement Hole
13. Water Tank
14. Hydraulic Cut-o
Parts
CAUTION: To avoid electrical shock, do not open any compartment of
this device that is not specied in the user instructions. Any repair work
for this device must be performed by a qualied Eva-Dry technician.
Specications
Performance:
Generates approximately 8oz of
water per day at 86F, 80% RH (rela-
tive humidity)
Components:
3”x3” Brushless Motor
16oz Holding Tank
6”(W) x 8.5” (H) x 5” (D)
Specications are subject to change

4
1. After removing all materials from the packaging, there should be
two items:
a. Petite Dehumidier
b. AC/DC Power adapter
2. Plug the DC power jack (10) of the AC/DC power adapter into
the DC power socket (7), then plug the AC connector (11) into
the appropriate main socket.
3. Press the “On/O button (1) to the “On” position. At this point,
the Petite Dehumidier should begin to operate. The green LED
light will be turned on. Listen and feel for the air blowing from
the dry air outlet (6) (Per Fig. 1)
4. To switch o the unit, press the “On/O button (1) to the “O”
position and the Petite Dehumidier will power down
Assembly for Use
Fig. 1 Fig. 2

5
When the water tank becomes full with approxi-
mately 16 ounces of water, the unit will automat-
ically switch o and the “Yellow” LED (3) will turn
on (Per Fig. 3)
To remove the water tank (13), rst switch the
Petite Dehumidier o by pressing the “On/O”
button to the “O” position. Remove the water
tank by grabbing it and sliding it towards you.
Release the plug in the water displacement hole
(12) by pulling the plug up. Empty the water into
the sink or another appropriate location. Push
the plug back into the water displacement hole
to seal the water tank. Slide the water tank back
into the Petite Dehumidier.
Removing the
Water Tank
Fig. 3

Before cleaning the Petite Dehumidier, unplug the AC connector from the
main outlet socket on the wall. Use a soft cloth to clean the surface of the
unit or use a brush to wipe the dust o of the grills of the air inlet.
1. CAUTION: Make sure to switch the “On/O” button to the “O posi-
tion” when the Petite Dehumidier is not in use.
2. Do not allow the AC/DC power adapter to come into direct contact
with water or damp surfaces. Position the power adapter in a place
where there is good air ventilation.
3. Keep the air inlet and outlet free from blocking materials such as
clothing, plastic bags, or papers.
4. If the unit has been properly connected but does not power on, have
the AC/DC power adapter and the Petite Dehumidier unit evaluated
by a qualied electrician.
5. Always keep the Petite Dehumidier in an up-right position to avoid
water leakage.
Cleaning
12157 West Linebaugh Avenue #152
Tampa, Florida 33626
To register warranties online, please visit www.eva-dry.com