EvaClean PX300ES User manual

Operaon Instrucons – EvaClean Infecon Prevenon Program
Please read the operaon manual for detailed instrucons and safety handling
© EarthSafe Chemical Alternatives, LLC. All rights reserved.
KILL CLAIMS CONCENTRATION DILUTION
Food contact surface sanitizer (No Rinse) 60 seconds contact time Food contact surface sanitizer (no rinse) – 100ppm- 200ppm (1) 3.3g tab / 2 gal
Hospital grade disinfectant claims (Bleach alt.) Cold & u virus’
(including H1N2), Salmonella & Staph
538 ppm (4) 3.3g tab / 2 gal
(1) 13.1g tab / 2 gal
Bloodborne pathogen, Herpes & Polio, Norovirus, MRSA & Ecoli, HIV
& Hep B claims, Many animal pathogens
1076 ppm (8) 3.3g tab / 2 gal
(2) 13.1g tab / 2 gal
C. Diff spore 10 minute claim 2153 ppm (16) 3.3g tab / 2 gal
(4) 13.1g tab / 2 gal
C. Diff spore 4 minute claim 4306 ppm (32) 3.3g tab / 2 gal
(8) 13.1g tab / 2 gal
1 0
0
0
!
Reference SDS for additional information
145 Wood Road Braintree, MA 02184
866-666-2305 | [e-mail]
www.evaclean.com
** Disclaimer: The Protexus Electrostac Sprayer™ has not been evaluated for use with soluons other than those from EarthSafe or the EvaClean Program. Disinfectants and
sanizers have diering usage guides, dwell mes, and kill claims which can impact applicaon results. EarthSafe makes no guarantees or warranes of any kind, either express
or implied, including but not limited to, tness for a parcular purpose. Use of the Protexus Electrostac Sprayer™ is at the user’s own risk. Improper care or use of the Protexus
Electrostac Sprayer™ resulng in damage to the unit is not covered under manufacturer’s warranty.
2.2 GALLON TANK
28 lbs at full capacity
16.8V BATTERY
For use in both PX300ES Backpack
& PX200ES Handheld sprayers
LOCK SWITCH
Easy On/Off
ADJUSTABLE STRAPS
Ergonomic comfort design
QUICK CONNECT CORD
For easy set up & disconnect
ADJUSTABLE NOZZLE
Ability to change particle
size for varied applications
LED BATTERY
INDICATOR

4. Handheld sprayer hose.
a. Connect the water line
(larger) hose to the sprayer.
b. Connect the electric line
(smaller) to the base of the
sprayer.
c. To remove water line from
electric gun handle, pull
back on quick release
coupler to remove
d. To remove electrical con-
nection push metal spring
loaded tab inward until
electric line is released.
5. Electrostatic on/off.
When the light is red, the
electrostatic component is on.
3
21
1. Sanizing: adjust to the
small nozzle seng.
2. Disinfecon: adjust to the
medium nozzle seng.
3. So surfaces: (linens/
carpet/outdoors) use
large seng.
5. Changing the 3-in-1 nozzle (PX50ES) settings. “Do not touch or insert
foreign object into the nozzle to avoid electric shock”. Adjust the
nozzle to the appropriate setting by using the nozzle wrench. Gently
rotate the wrench in the clockwise direction until you hear a “click.”
* PLEASE NOTE: If your nozzle becomes clogged, soak in hot soapy
water and blow out with pressurized air to remove blockage.When not
properly cleaned, the sprayer nozzle residual chemical deposits build
up. Deposit build up results in decreased bar pressure and decreased
spray patterns.
7. Optimal spraying distance. To ensure optimal electrostatic performance
always keep your hand rmly wrapped around the handle and in contact
with the ground strap. Keep a distance of 2-3 feet from desired surface. Pull
the trigger and spray evenly.
8. Drain unit before storage. Never store the sprayer with a full tank inserted.
Remove tank, prior to storing the sprayer, and use the tank lid to seal any
remaining PURTABS solution for the next use. Evacuate water fully from
sprayer tubing prior to storing. Regularly ush both sprayer and nozzles
by lling the tank with warm water and spraying each nozzle setting for
approximately 30 seconds. Wipe nozzle area dry after each use.
IMPORTANT: Battery
door must be closed at all
times during use. Failure
to close the battery door
can cause damage if the
battery gets wet.
BATTERY OPERATION
1. Charge the battery for two hours before inserting the Protexus 16.8
volt battery into the backpack.
a. Plug the charger into an outlet and insert the battery until the power level
indicator shows a full charge.
2. Insert battery into backpack.
a. Open battery door by turning the knob counter clockwise
b. Align battery grooves and push battery until it clicks into the locked position.
c. Tighten the knob clockwise until secure.
SPRAYER SETUP
1. Remove the Sprayer Tank. Pull the top tank latch release to unlock,
(see image) and carefully remove the tank.
2. Diluting PURTABS solution. After selecting your concentration, ll the
tank according to the dilution chart. Drop the PURTABS ** tablet into the
tank. Close the tank lid, and wait approx. 2 minutes for the tablet to dissolve
completely. Label the date and ppm on a tank label. Please reference the
dilution chart for appropriate tablet size.
3. Inserting tank back into sprayer. Place the tank on a at surface, and
align the grooves of the tank with the sprayer. Insert the tank into the
sprayer until you hear the click of the tank locking back into place. Secure
the top latch back into place.
4. Apply appropriate tank labels. Secure tank measurement guide label
alongside the edge of the tank. Apply Dilution (ppm) label in a visible location
on the tank. Labels may be removed and replaced as needed.