
Rotate the dial of the tank lock towards
the unlock posion. (picture of tank lock) Pull the tank release ring
and carefully remove the tank. Hold on to the tank while pulling the
ring or the tank may fall.1
Fill the tank up to the ll line with
warm water. Drop the tablet into the tank. Close the tank with the
lid, and wait about 2 minutes for complete diluon prior to re-
inserng the tank into the sprayer. Label the date of diluon on the
tank. Please reference the diluon table for appropriate tablet size.
Place the tank on a at surface,
and align the groves of the tank with the sprayer. Insert the tank
into the sprayer unl you hear the click of the release ring locking
back into place. Rotate the dial of the tank lock towards the lock
posion to secure the tank in place.
Turn on the electrostac component by
sliding it to the “on” posion.
1Locking the trigger: Press on the trigger lock to engage the lock prior to removing the tank, storing
the sprayer, and in between uses.
© EarthSafe Chemical Alternatives, LLC. All rights reserved.
1. adjust to the
small nozzle setting. (9C)
2. adjust to
the medium nozzle
setting. (8C)
3. (linens/
carpet/outdoors) use
large setting. (4F)
21
0
5. “Do not touch or insert foreign
object into the nozzle to avoid electric shock”. Adjust the nozzle to
the appropriate setting by using the nozzle wrench. Gently rotate
the wrench in the clockwise direction until you hear a “click.”
If your single or tri-nozzle becomes clogged, soak in hot soapy water and blow out with
pressurized air to remove blockage.When not properly cleaned, the sprayer nozzle residual chemical
deposits build up. Deposit build up results in decreased bar pressure and decreased spray patterns.
(reference nozzle care instructions)
To ensure opmal electrostac performance
always keep your hand rmly wrapped around the handle and in
contact with the ground strap. Keep a distance of 2-3 feet from
desired surface. Pull the trigger and spray.
Never store the sprayer with a full tank.
Remove tank, prior to storing the sprayer, and use the tank lid to
seal any remaining PurTabs soluon for the next use. Regularly
ush the sprayer and nozzles by lling the tank with warm water and
spraying each nozzle seng for approximately 30 seconds. Evacuate
water fully from sprayer tubing prior to storing. Wipe nozzle area dry
aer each use.