EVE HC-DIESEL-90 PLUS User manual
1
Cooker Hood
HC-DIESEL-90 PLUS
บริษัท สยามแมเนอร์ กรุ๊ป จากัด
660 ซอยนวมิทร์ 91 แยก 3-42
แขวงนวมินทร์ เขตบึงกุ่มกรุงเทพฯ 10240
โทรศัพท์: 02-033-5400
โทรสาร: 02-033-5409
ศุนย์บริการหลังการขาย:
โทรศัพท์: 02-033-5422
www.eve.co.th
Instruction Manual
2
Content
2
3
4
5
6
3
a)
B)
a) 4 Pa (4 * 10-5
B)
C)
D)
E)
F)
A)
B)
C)
D) barbecue
E)
F)
G)
H)
4
5
1.
2. 65-75cm (20-30
3. 4
4. ST4*30 mm. ST4x40 mm.
2
5. 4 3
6. 4 cable tie 4
5
5
7. ST4*8 mm 2
6
8. ST4*30mm 2
7
9. 2 ST4*8 8
•
•
•
•
6
•
•
•
•
•
V-FLAP
•
•
•
•
➢
➢ !
V-FLAP
7
LED
, ,
1
standby mode
2
3 3
, , LED , ,
→ →
→→
4
5
8
U
U
➢
9
:
•
•
:
•
•etc
:
()
10
•
•
•
•
•
•
11
•
•2/3
•
•
•
:
•
•
•
LED
•
•
•
•LED DBR-1.5/65-S-64
•: 2x1.5 w
•: DC 12V
•:
12
(
)
Directive 2012/19/EU
13
This manual explains the proper installation and use of your cooker hood, please
read it carefully before using even if you are familiar with the product. The
manual should be kept in a safe place for future reference.
Never to do:
•Do not try to use the cooker hood without the grease filters or if the filters
are excessively greasy!
•Do not install above a cooker with a high level grill.
•Do not leave frying pans unattended during use because overheated fats or oils might catch fire.
•Never leave naked flames under the cooker hood.
•If the cooker hood is damaged, do not attempt to use.
•Do not flambé under the cooker hood.
CAUTION: Accessible parts may become hot when used with cooking appliances.
•The minimum distance between the supporting surface for the cooking vessels on the hob and
the lowest part of the cooker hood. (When the cooker hood is located above a gas appliance, this
distance shall be at least 65 cm)
•The air must not be discharged into a flue that is used for exhausting fumes from appliances
burning gas or other fuels. Range hoods and other cooking fume extractors may adversely affect
the safe operation of appliances burning gas or other fuels (including those in other rooms) due
to back flow of combustion gases. These gases can potentially result in carbon monoxide
poisoning. After installation of a range hood or other cooking fume extractor, the operation of
open flued gas appliances should be tested by a competent person to ensure that back flow of
combustion gases does not occur.
Always to do:
•Important! Always switch off the electricity supply at the mains during installation and
maintenance such as light bulb replacement.
•The cooker hood must be installed in accordance with the installation instructions and all
measurements followed.
•All installation work must be carried out by a competent person or qualified electrician.
•Please dispose of the packing material carefully. Children are vulnerable to it.
•Pay attention to the sharp edges inside the cooker hood especially during installation and cleaning.
•Make sure the ducting has no bends sharper than 90 degrees as this will reduce the efficiency of
the cooker hood.
Warning: Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
•Warning: Before obtaining access to terminals, all supply circuits must be disconnected.
SAFETY INSTRUCTION
14
Always to do:
•Always put lids on pots and pans when cooking on a gas cooker.
•When in extraction mode, air in the room is being removed by the cooker hood. Please make sure
that proper ventilation measures are being observed. The cooker hood removes odours from
room but not steam.
•There shall be adequate ventilation of the room when the cooker hood is used at the same time
as appliances burning gas or other fuels.
•Cooker hood is for domestic use only.
•If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
•If This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
Always to do:
•Caution: The appliance and its accessible parts can become hot during operation. Be careful to
avoid touching the heating elements. Children younger than 8 years old
INSTALLATION
If you have an outlet to the outside, your cooker hood can be connected as below picture by means
of an extraction duct (enamel, aluminum, flexible pipe or non-flammable material with an interior
diameter of 150mm)
INSTALLATION
Installation with the outside vent
15
1. Before installation, turn the unit off and unplug it from the outlet.
2. The cooker hood should be placed at a distance of 65~75cm above the cooking surface for best
effect.
3. After decide the cooker hood height, measure the position of the holes for hanging the hood
and inside chimney bracket. Drill 4 pcs φ8 holes, they are for fixing intside chimney bracket and
the hood,and keep the hood level. The fixed position of the outside chimney bracket is the
highest place of outside chimney. See pic 2.
4. Screw 2 pcs of ST4*30mm screws on the wall with wall plugs and then use 2 pcs of ST4×40mm
screws to fix the inside chimney bracket. See pic 2.
5. Fix the glass onto the cooker hood body with screws ,washers and wall plugs. See pic 3.
16
6. Equip the outlet to the hood body and fix the expansion pipe to the outlet with a cable tie. See
pic 4. Put the cooker hood on the wall mounted screws. See pic 5.
7. Install the outside chimney bracket onto the outside chimney with 2 pcs of ST4*8mm screws,
here should be sure the inside chimney can be moved inside freely. See pic 6.
8. After adjust the height,fix the body with 2 pcs of ST4*30mm safety screws. Note: The two safety
vents are positioned on the back housing, with a diameter of 6mm. Then put the two chimneys
together onto the cooker hood body, also lead the expansion pipe outside of the room. See pic
7.
9. Adjust the height of the inside chimney into the suitable height, and fix the inside chimney to
the inside chimney bracket with 2 pcs of ST4*8mm screws. See pic 8.
HINTS FOR EXHAUST DUCT INSTALLATION
The following rules must be strictly followed to obtain optimal air extraction:
•Keep expansion pipe short and straight.
•Do not reduce the size or restrict the expansion pipe.
•When using the expansion pipe always install the pipe pulled taut to minimize pressure loss.
•Failure to observe these basic instructions will reduce the performance and increase noise
17
levels of the cooker hood.
•Any installation work must be carried out by a qualified electrician or competent person.
•Do not connect the ducting system of the hood to any existing ventilation system which is being
used for any other appliance ,such as warmer tube, gas tube , hot wind tube.
•The angle of the bend of the expansion pipe should not be less than 120º; you must direct the
pipe horizontally, or, alternatively, the pipe should go up from the initial point and should be led
to an outer wall.
•After the installation ,make sure that the cooker hood is level to avoid grease collection at on
end.
•Ensure the expansion pipe selected for installation complies with relevant standards and is fire
retardant.
If the cooker hood does not have an assembled V-flap 1, you should mount the half-parts to its
body. The images only show an example of how to mount the V-flap, because the outlet may vary
according to different models and configurations.
To mount the V-flap 1 you should:
• Mount two half-parts 2 into the body 6;
• the pin 3 should be top oriented;
• the axis 4 should be inserted into the holes 5 on the body;
• repeat all the operations for the 2nd half-part.
WARNING
•For safety reason, please use only the same size of fixing or mounting screws which are
recommended in this instruction manual.
•Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards.
MOUNTING OF THEV-FLAP
18
Touch control with LED display
1. Press the “Power” button, the button control the “on” & “off ” of the hood.
2. Press the button “Speed” time after time, the motor runs as low / mid / high / low / mid…, the
speed runs circularly; and the LED display will indicate as 1-2-3-1-2… circularly.
3. Press “Lamp” button, the light is on, press this button again, the light is off. Please note the
Lamp is not under control of the on/off button.
4. When the hood is working, if press the “Timer” button, the hood will go into the status of
acquiescent working (acquiescent time is 9mins), and then, LED display will be shown 9.8.7.6
...decreasing by 1,when time is up, the hood will be off automatically and the lamp will
extinguish. If pressing “Timer” button, the hood will go in or go out “Timer” function.
Fault
Possible Cause
Solution
Light on, but motor
does not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact service center.
Motor failed
Contact service center.
Light does not work,
motor does not work
House fuses blown
Reset/Replace fuses.
Mains power cable is loose or
disconnected
Refit mains power cable to power
outlet.
START USING YOUR COOKER HOOD
TROUBLE SHOOTING
19
Switch power outlet on.
Oil leakage
One way valve and the outlet are
not tightly sealed
Take down the one way valve and
seal with sealant.
Leakage from the connection of
chimney and cover
Take chimney down and seal.
Lights not working
Broken or faulty bulbs
Replace bulbs as per this
instruction.
Insufficient suction
The distance between the cooker
hood and the gas top is too far
Refit the cooker hood to the correct
distance.
The Cooker hood
inclines
The fixing screw is not tight
enough
Tighten the hanging screw and
make it horizontal.
CAUTION:
•Before maintenance or cleaning is carried out, the cooker
hood should be disconnected from the mains power
supply. Ensure that the cooker hood is switched off at the
wall socket and the plug removed.
•External surfaces are susceptible to scratches and
abrasions, so follow the cleaning instructions to ensure the
best possible result is achieved without damage.
GENERAL:
•Cleaning and maintenance should be carried out with the appliance cold especially when
cleaning.Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life expectancy.Dry
with a clean soft cloth. A specialized stainless steel cleaning fluid may be used.
CAUTION!
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please
contact the service centre if in any doubt before undertaking any of the above. Always
disconnect the unit from the power source when opening the unit.
MAINTENANCE AND CLEANING
STAINLESS STEEL
20
IMPORTANT:
Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly
crisscross scratching patterns from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and
well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after
cleaning.
IMPORTANT:
Using neutral detergents and avoid using harsh cleaning chemicals, strong household
detergents or products containing abrasives,as this will affect the appearance of the appliance
and potentially remove any printing of artwork on the control panel and will void manufactures
warrantee.
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water with a mild
detergent and then brush it gently with a soft brush. Do not apply too much
pressure so as to avoid any damage to it . (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. It is advisable not to use
rinse aid.
• To install filters for the following four steps:
- Angle the filter into the slots at the back of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
GREASE MESH FILTERS
INSTALLING GREASE FILTERS
Other EVE Ventilation Hood manuals
EVE
EVE HF-BK102AT-60 User manual
EVE
EVE HC-ARIA-90 User manual
EVE
EVE HC-KRONOS-90 User manual
EVE
EVE Olympus 90 CM User manual
EVE
EVE HS-BG62-60 User manual
EVE
EVE MOONLESS 90 User manual
EVE
EVE HC-HEE52TC-90 User manual
EVE
EVE Olympus 90 CM User manual
EVE
EVE BLAST 90 CM User manual
EVE
EVE HF-HSM102AT-60 User manual
Popular Ventilation Hood manuals by other brands
Broan
Broan best IS2304SS manual
Sirius Satellite Radio
Sirius Satellite Radio SU-DD2-L TC Installation, Use and Maintenance Instruction
Bellini
Bellini BRA603SX2 Installation & operation instructions
Blue Mountain
Blue Mountain TSEF18 Installation and specification guide
S&P
S&P TD EVO 100 instruction manual
Bauknecht
Bauknecht DC 5460 IN/1 Instructions for use
