EVE HF-BK102AT-60 User manual
1
Cooker Hood
HF-BK102AT-60
บริษัท สยามแมเนอร์ กรุ๊ป จากัด
660 ซอยนวมิทร์ 91 แยก 3-42
แขวงนวมินทร์ เขตบึงกุ่มกรุงเทพฯ 10240
โทรศัพท์: 02-033-5400
โทรสาร: 02-033-5409
ศุนย์บริการหลังการขาย:
โทรศัพท์: 02-033-5422
www.eve.co.th
Instruction Manual
2
Content
2
3
4
5
6
3
a)
B)
a) 4 Pa (4 * 10-5
B)
C)
D)
E)
F)
A)
B)
C)
D) barbecue
E)
F)
G)
H)
4
5
65-75cm (20-30 1
A
1. 4 8 mm.
2
2.
3.
4.
5.
6.
2
5
B
1. 4 6 mm.
2. 4
3.
3
: 2
A :
B :
4
5
6
•
•
•
•
•
•
• 120º
•
•
(Push Button)
1.
2.
➢
➢ !
7
3.
4.
5.
U
U
➢
8
:
•
•
:
•
• etc
:
()
9
•
•
•
•
10
•
• 2/3
•
•
•
:
•
•
•
LED
•
•
•
•LED DBR-2/65-H-64
•: 2x2 w
•: AC 110-240V
•:
•
•
11
(
)
Directive
2012/19/EU
12
This manual explains the proper installation and use of your cooker hood, please
read it carefully before using even if you are familiar with the product. The
manual should be kept in a safe place for future reference.
Never to do:
•Do not try to use the cooker hood without the grease filters or if the filters
are excessively greasy!
•Do not install above a cooker with a high level grill.
•Do not leave frying pans unattended during use because overheated fats or oils might catch fire.
•Never leave naked flames under the cooker hood.
•If the cooker hood is damaged, do not attempt to use.
•Do not flambé under the cooker hood.
CAUTION: Accessible parts may become hot when used with cooking appliances.
•The minimum distance between the supporting surface for the cooking vessels on the hob and
the lowest part of the cooker hood. (When the cooker hood is located above a gas appliance, this
distance shall be at least 65 cm)
•The air must not be discharged into a flue that is used for exhausting fumes from appliances
burning gas or other fuels. Range hoods and other cooking fume extractors may adversely affect
the safe operation of appliances burning gas or other fuels (including those in other rooms) due
to back flow of combustion gases. These gases can potentially result in carbon monoxide
poisoning. After installation of a range hood or other cooking fume extractor, the operation of
open flued gas appliances should be tested by a competent person to ensure that back flow of
combustion gases does not occur.
Always to do:
•Important! Always switch off the electricity supply at the mains during installation and
maintenance such as light bulb replacement.
•The cooker hood must be installed in accordance with the installation instructions and all
measurements followed.
•All installation work must be carried out by a competent person or qualified electrician.
•Please dispose of the packing material carefully. Children are vulnerable to it.
•Pay attention to the sharp edges inside the cooker hood especially during installation and cleaning.
•Make sure the ducting has no bends sharper than 90 degrees as this will reduce the efficiency of
the cooker hood.
Warning: Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
•Warning: Before obtaining access to terminals, all supply circuits must be disconnected.
SAFETY INSTRUCTION
13
Always to do:
•Always put lids on pots and pans when cooking on a gas cooker.
•When in extraction mode, air in the room is being removed by the cooker hood. Please make sure
that proper ventilation measures are being observed. The cooker hood removes odours from
room but not steam.
•There shall be adequate ventilation of the room when the cooker hood is used at the same time
as appliances burning gas or other fuels.
•Cooker hood is for domestic use only.
•If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
•If This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
Always to do:
•Caution: The appliance and its accessible parts can become hot during operation. Be careful to
avoid touching the heating elements. Children younger than 8 years old
If you have an outlet to the outside, your cooker hood can be connected as below picture by
means of an extraction duct (enamel, aluminum, flexible pipe or non-flammable material
with an interior diameter of 120mm)
INSTALLATION
Installation with the outside vent
14
Before installation, turn the unit off and unplug it from the outlet.
The cooker hoods should be placed at a distance of 65-75cm from the cooking surface for
best effect. See pic 1.
Pic 1
Method A:
1. To install onto the wall, drill 4 holes of Ø 8mm on a suitable place according with the
centre distance of hole in the back of the cooker hood. See pic 2.
2. Insert the nut into the holes.
3. Insert the screws into the nuts and tight.
4. Put up the cooker hood onto the fixed screws.
5. Then use the attached accessories enclosed to turn the screws into the two holes of
inside the hood, and then fix the screws to tighten the hood onto the wall.
6. Put the outlet onto the cooker hood.
Pic 2
Method B:
1. Drill 4 holes of Ø 6mm at the bottom of the hanging cupboard.
2. Put the outlet to the cooker hood, then install the cooker hood on the bottom of the
cupboard, tighten the cooker hood with enclosed 4 screws.
15
3. Install the adjusted board on the bottom of the hood in order to keep out the gap
between hood back and cupboard. See pic 3.
Pic 3
Noice: There are 2 methods for ventilation, including ' horizontal ventilation' and ' vertical
ventilation'. Please pay attention to the ventilation method when installation.
Horizontal ventilation: See pic 4A, please use the cover to seal the outlet on the top, then
the air can be vented from back.
Vertical ventilation: See pic 4B, please use the cover to seal the outlet on the back, then the
air can be vented from top.
Pic 4
Air ventilation setting
Outdoor air ventilation: Turn the adjuster to outdoor position (pic 5A), install the outlet, turn
on the cooker hood, then the air will be vented from the outside outlet.
Indoor air ventilation: Turn the adjuster to indoor position (pic 5B), install the outlet cover,
turn on the cooker hood, then the air can be vented from the inside outlet.
Pic 5
16
Touch control with LED display
Push button
1) Push the stop button, and the motor will stop.
2) Push the low button, and the motor will run at low speed.
3) Push the middle button, and the motor will run at mid speed.
4) Push the high button, and the motor will run at high speed.
5) Push the light button and the two lights will illuminate. Push it again and the light will
turn off.
Fault
Possible Cause
Solution
Light on, but motor
does not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact service center.
Motor failed
Contact service center.
Light does not work,
motor does not work
House fuses blown
Reset/Replace fuses.
Mains power cable is loose or
disconnected
Refit mains power cable to power
outlet.
Switch power outlet on.
Oil leakage
One way valve and the outlet are
not tightly sealed
Take down the one way valve and
seal with sealant.
Leakage from the connection of
chimney and cover
Take chimney down and seal.
WARNING
•For safety reason, please use only the same size of fixing or mounting screws which are
recommended in this instruction manual.
•Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards.
START USING YOUR COOKER HOOD
TROUBLE SHOOTING
17
Lights not working
Broken or faulty bulbs
Replace bulbs as per this
instruction.
Insufficient suction
The distance between the cooker
hood and the gas top is too far
Refit the cooker hood to the correct
distance.
The Cooker hood
inclines
The fixing screw is not tight
enough
Tighten the hanging screw and
make it horizontal.
CAUTION:
•Before maintenance or cleaning is carried out, the cooker
hood should be disconnected from the mains power
supply. Ensure that the cooker hood is switched off at the
wall socket and the plug removed.
•External surfaces are susceptible to scratches and
abrasions, so follow the cleaning instructions to ensure the
best possible result is achieved without damage.
GENERAL:
•Cleaning and maintenance should be carried out with the appliance cold especially when
cleaning.Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life expectancy.Dry
with a clean soft cloth. A specialized stainless steel cleaning fluid may be used.
IMPORTANT:
Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly
crisscross scratching patterns from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and
well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after
cleaning.
CAUTION!
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please
contact the service centre if in any doubt before undertaking any of the above. Always
disconnect the unit from the power source when opening the unit.
MAINTENANCE AND CLEANING
STAINLESS STEEL
18
IMPORTANT:
Using neutral detergents and avoid using harsh cleaning chemicals, strong household
detergents or products containing abrasives,as this will affect the appearance of the appliance
and potentially remove any printing of artwork on the control panel and will void manufactures
warrantee.
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water with a mild
detergent and then brush it gently with a soft brush. Do not apply too much
pressure so as to avoid any damage to it . (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. It is advisable not to use
rinse aid.
• To install filters for the following four steps:
- Angle the filter into the slots at the back of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
CARBON FILTER
Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be
changed every 3 to 6 months according to your cooking habits. The installation procedure of
activated carbon filter is as below:
1. In order to install the activated carbon filter, the metallic anti-grease filter should be
detached first. Press the lock and pull it downward.
2. Insert the carbon filter into the rectangular hole, fitting it over the motor.
3. After inserting the front edge of the carbon filter into the slot on the cooker hood. Lower the
back edge of the carbon filter, until it clicks into place at the rear of the rectangular hole. Raise
the two fixing bars, until they are horizontal over the carbon filter.
GREASE MESH FILTERS
INSTALLING GREASE FILTERS
19
4. Place the Al. filter back to position.
Apply reverse procedure to uninstall the carbon filter
IMPORTANT
•The bulb must be replaced by the manufacturer, its service agent or
similarly qualified persons.
•Always switch off the electricity supply before carrying out any
operations on the appliance. When handling bulb, make sure it has
completely cooled down before any direct contact with hands
•When handling bulbs hold with a cloth or gloves to ensure
perspiration does not come in contact with the bulb as this can reduce
the life of the bulb.
Note:
⚫Before changing the lights, make sure that the appliance is turned off and unplugged.
⚫Protect against danger when changing lights, such as wearing gloves.
Changing the lights:
•Remove the grease filter.
•Use a screwdriver to remove the 4pcs screws on the large glass and carefully remove the
glass.
•Then slightly pull the light connecting wire out, and
dismantle the terminal of the light connecting
wire.Replace the lamp.
•Apply the reverse procedure to install the light back.
•ILCOS D code for this lamp is: DBR-2/65-H-64
•Lamp modules –round lamp
BULB REPLACEMENT
NOTE:
•Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.
•When activated carbon filter attached, the suction power will be lowered
20
•Max wattage: 2×2W
•Voltage range: AC 110-240V
•Dimensions:
This product is marked with the symbol on the selective sorting of waste
electronic equipment. This means that this product must not be disposed
of with household waste but must be supported by a system of selective
collection in accordance with Directive 2012/19/EU. It will then be
recycled or dismantled to minimize impacts on the environment, electrical
and electronic products are potentially dangerous for the environment and
human health due to the presence of hazardous substances.For more
information, please contact your local or regional authorities.
NOTE:
The following shows how to reduce total environmental impact (e.g. energy use) of the cooking
process).
(1) Install the cooker hood in a proper place where there is efficient ventilation.
(2) Clean the cooker hood regularly so as not to block the airway.
(3) Remember to switch off the cooker hood light after cooking.
ENVIRONMENTAL PROTECTION
Other EVE Ventilation Hood manuals
EVE
EVE HC-DIESEL-90 PLUS User manual
EVE
EVE HF-HSM102AT-60 User manual
EVE
EVE HC-ARIA-90 User manual
EVE
EVE HC-HEE35C-60 User manual
EVE
EVE Olympus 90 CM User manual
EVE
EVE HC-HEE52TC-90 User manual
EVE
EVE BLAST 90 CM User manual
EVE
EVE HS-BG62-60 User manual
EVE
EVE HC-KRONOS-90 User manual
EVE
EVE Olympus 90 CM User manual
