Everlasting Comfort Arm Rest Pads User manual

Arm Rest Pads
USER MANUAL

Wrap each strap underneath the arm rest and loop
the strap through the opening of the buckle.
4
Unwrap each strap from the arm rest pad.
1
Pull each strap out from its buckle.
2
Place the armrest pad with its white non-slip gel
rubber bottom side down onto the armrest of a chair.
The velcro straps should hang on the outside edge of
the armrest, as shown in the diagram below.
3
HOW TO USE:
STRAP ON OUTSIDE
BUCKLES ON INSIDE
LOGO FACING FRONT
PLACE THE PAD WITH L
STICKER UNDER YOUR LEFT
ARM
PLACE THE PAD WITH R
STICKER UNDER YOUR
RIGHT ARM
R
L

Pull Each Strap Down and Back Under Arm Rest
5
Fasten straps and roll excess strap under and
towards arm rest (fuzzy side facing up).
6
OPTIONAL: You can cut the excess strap using any
household scissors, however, it may prevent you from
using the arm rest pads on a different arm rest in the
future. The fit may be different.
UNZIP

Unzip the cover from the back of the armrest pad and toss
it into the wash. Machine wash cold. Do not put the cover
in the dryer. Air dry only.
HOW TO CLEAN:
HAVE AN ISSUE WITH YOUR ARM REST PADS?
Enjoy-hassle free replacements:
if your arm rest pads are defective
or damaged, we will ship you a new
set ABSOLUTELY FREE.
For fast and knowledgeable service,
get in touch with one of our
customer service experts right
now!
Email: [email protected]
WRITE A MESSAGE
TO SUPPORT
1. Unroll any excess part of the strap and/or pull the
straps apart from the double-sided velcro.
2. Lift the arm rest pad from the arm rest of the chair.
3. Pull the straps out of the buckle to detach.
DETACHING THE ARM REST PADS
To check out more of the products we offer visit:
everlastingcomfort.net