Everpure 150B D-Clor EV949812 User manual

S1B Aircraft Water Filter
Part No. EV943000
S1B Assembly
P/N EV943000 (1 pack)
150B D-Clor™
Replacement
Cartridge
P/N EV949812
(12 Pack)
150G D-Clor™
Replacement
Cartridge
P/N EV949000
(12 Pack)
150GP D-Clor™
Replacement
Cartridge
P/N EV949212
(12 Pack)
150GY D-Clor™
Replacement
Cartridge
P/N EV949012
(12 Pack)
0
5
10
15
20
25
0 0.5 1 1.5 2 2.5
FLOW RATE (GPM)
INITIAL PRESSURE DROP (PSI)
PRESSURE DROP CHARACTERISTICS
S1B Shell Only
S1B w/150G cartridge
S1B w/150GP cartridge
S1B w/150GY cartridge
S1B w/150B cartridge
REPLACES AL-21SG (P/N 770006)
Premium Quality Water Filtration
Created for Use in Aircraft
BENEFITS
Improves aircraft water by reducing chlorine taste and odor•
and other off tastes and odors
Filters out dirt and other suspended matter•
Vessel made of durable “300 Series” stainless steel•
Designed for use with all Everpure D-Clor™ Cartridges•
FAA-PMA Approved•
INSTALLATION TIPS
To service, shut off inuent water supply, open service tap,•
remove the V-Band Clamp, and unscrew cartridge.
After replacing cartridge, air should be released from the top•
vent.
Flush the cartridges by running water through lter at full•
ow at the service tap for three minutes, or until water runs
clear.
OPERATION TIPS
Change cartridges as indicated on the cartridge data sheet.•
Always Flush all new filter cartridges at time of•
installation.
INLET AND OUTLET CONNECTIONS
Bottom IN / Bottom OUT• Top Vent
Inlet and Outlet: 3/8"—18NF (3/8" tube union)•
1/4" NPT Female Threads Combination Fittings•
REPLACEMENT CARTRIDGES
All D-Clor™ cartridges reduce chlorine taste and odor, and•
other taste and odor while ltering out dirt and suspended
matter. See chart for different pressure drop characteristics.
In addition to reducing taste and odors, the 150GP cartridge•
inhibits limescale build-up. Limescale prevention is particu-
larly important in applications involving hot water heaters
and coffee makers.

LIMITED WARRANTY OF PHYSICAL QUALITY
If, within eighteen months after manufacture or twelve months after purchase (whichever
occurs first), any part of Pentair Filtration, Inc.’s manufacture which is returned to its factory,
shipping charges prepaid, is found to be defective in material or workmanship in the judge-
ment of Pentair Filtration, Inc.’s engineers, Pentair Filtration, Inc. will repair or replace such
part at no charge, f.o.b., Sheboygan factory. Pentair Filtration, Inc., however, shall not be
liable for damages or delays caused by any defective material or workmanship, or by failure
of any parts due to normal wear and tear. Pentair Filtration, Inc. will not be responsible for
products which malfunction due to user neglect or unauthorized modification.
NOTE: Some states do not allow limitations on how long an implied warranty lasts, so the
above limitation may not apply to you. Similarly, some states do not allow the exclusion or
limitation of consequential or incidental damages, so the above limitation or exclusion may not
apply to you. This warranty gives you specific legal rights and you may also have other rights
which may vary from state to state.
Pentair Filtration, Inc.
502 Indiana Avenue - P.O. Box 1047
Sheboygan, Wisconsin 53082-1047
Phone [phone] Fax [phone]
International Phone [phone] International Fax [phone]
www.everpure.com
PARTS LIST & DIMENSIONS
Item
Number Description Part Number
1 Top, Polished Stainless Steel EV011400
2 Gasket (ATA Packaged) EV034401
3 Quick-Opening V-Band EV013400
4D-Clor™ Cartridge
150G, 150GY, 150B, 150GP
See front page
for Part Number
5 Shell, Polished Stainless Steel EV012300
SIDE
VIEW
TOP
VIEW
(19.7 cm)
(1.9 cm)
(10.3 cm)
1
2
3
4
5
1-7/8
4-1/16
7-3/4
(14.6 cm)
(12.5 cm)
5-3/4
4-15/16
©2007 Pentair Filtration, Inc. SH147501 AU07
SPECIFICATIONS
Dimensions
73⁄4" (19.7 cm) H x 415⁄16" (12.5 cm) D
Including V-Band: 53⁄4" (14.6 cm) D
Net Weight
21⁄2lbs (1.2 kg) including cartridge
Inlet and Outlet Connections: Bottom IN / Bottom OUT
Top Vent
Inlet and Outlet: 3/8" NPT Male Pipe Threads and
1/4" NPT Female Threads Combination Fittings
Service Flow Rate
Minimum 0.5 gpm (1.9 L/min)
Maximum 1.67 gpm (6.32 L/min)
Working Pressure
Up to 125 psi (8.62 bar), non-shock
Maximum Temperature
160°F (71.1°C)
No electrical connection required.
53⁄4"
415⁄16"
41⁄16"
17⁄8"
73⁄4"