How to use your Ewban Steam Mop
•When setting up. Make sure the unit is NOT
plugged into the mains.
•nit is supplied with carpet glider in position.
If using on hard floor, remove carpet glider
(Fig.2) using tabs on each side, before
attaching the fabric cloth (Fig.3).
•nscrew the cap of the water tank.
•When empty, using the measuring jug
supplied, add 400ml of water to the tank and
screw the top on firmly (Fig.4).
•Place plug into the wall socket and turn on.
•With the unit resting on the standing pad, use
the foot operated on/off switch to turn the unit
on.
•When the unit is on, the ”on” light will
illuminate.
•After approximately three minutes the steam
starts emitting slowly. At this point the
machine is ready for use. A small amount of
water discharge may be seen, this is normal,
at first.
•To clean your floor, move the unit slowly
across the floor.
•For tough stains on carpet, additional
cleaning may be required.
•To release go flat handle, place your foot on
the rear of the unit and push the handle
towards the floor.
•As the unit uses water, the indicator light will
illuminate intermittently.
•When the light is constant, the unit must be
refilled. A full tank will last up to 20 minutes
on a hard floor.
•The unit must be turned off at the wall prior to
refilling.
•When you have finished cleaning, use the
foot operated on/off switch to turn the
machine off.
•After a period of 20 minutes the cap can be
removed and the unit emptied of any
remaining water.
•The fabric cloth is hand washable.
•Please note, the wheels on the product are
not intended to be in contact with the floor
when in use.
Steam Mop
3
CAUTION
•When Steam Mop is warming
up or cooling down, ensure that
it is placed on the standing pad
to avoid damage to flooring.
•If removing pads, or carpet
glider before it is allowed to
cool, use appropiate safety
gloves.
Fig.1
Fig.2
Fig.3
Fig.4