Excel Enbeam 208-506 User manual

Enbeam Fibre Optic Splice
Closure 208-506 Instruction Manual
1. General Introduction
208-506 The Enbeam bre splice enclosure has been designed to house bre optic connections for external applications and
the distribution of bre cables where a high level of water resistance is required. It is widely used in many applications: pole-
mounting and wall-mounting. With an IP rating of IP68
The compact size gives exibility to the installation and oers up to 48 splices via its hinged splice tray array and 24 sc simplex
adaptor positions for use with Passive optical splitters.
2. Specication
3. Structure
4. Installation Instruction
Dimensions (mm) 380x245x130 Max. capacity (single bre) 48
Weight (kg) 3~3.5 Sealing type Mechanical
Cable ports
1 input cable port for un-
cut cable from diameter
from10~17.5mm.
24 output cable port for cable
diameter 4mm.
Single splice tray capacity
(Single bre) 12
Splice tray quantity 1~4
3.1 Closure and accessories (Picture 1)
Picture 1
Installation
Preparation
• Check all accessories of the splice enclosure and cable before installation.
• All components of the splice enclosure must be kept dry and clean.
• The working site must be kept clean (free from moisture and dust).
Cable Preparation
• For uncut cable mark and strip the outer jacket 200cm
200cm
• Cut back the strength member to 5cm
5cm

To open
• Open the 4 x compression latches using a at bladed screwdriver
• Loosen the 2 x hexagonal bolts until the enclosure opens (do not remove completely)
• To prevent the cover closing during installation, use the cover locking bracket and inset as shown below
Cover locking
bracket
Oval port for uncut cable
• Taking a cable with 200cm of cable jacket removed mid span, make a loop
• Take the Oval rubber seal and cut as shown
• Feed the loop through the compression gland and rubber seal
• Feed the cable into the enclosure through the oval port
• Secure the cable ends to the internal cable clamp

• Secure the strength member to the end of the cable clamp
• With the cable fully secured push the rubber seal into the oval port followed by the compression gland and tighten the
hexagonal bolts.
• Cables should be routed to the side channels of the splice trays, all Fibre should be protected by transit tube of spiral wrap
(supplied) and bres fed to each tray as required.
• Bare bres are routed around the splice tray allowing for additional length of bre for rework. Each bre is then spliced and
splice protectors placed in to the space provided.
Fibre routing
Drop cable installation
• Insert cable as shown below

MF1501/10/18
• Insert into required port and tighten
• Remove tool and x cable with a nylon cable tie as shown
• Tighten the 2 x hexagonal bolts
• Close the 4 x compression latches
To close
6. Installation
7. Main technical data
Wall mounting Pole mounting
7.1 Environmental temperature: -40ºC~+65ºC
7.2 Optical performance: No signicant additional attenuation
7. 3 I P6 8