Exos Mini User manual

User Manual
Exos Mini
Pin Bone Remover
Revised: 2015-01-07

Thank you for choosing a hand held Pin Bone
remover from Exos. We hope you will find a tool
that gives you the speed, yield and efficiency that
you expect from a professional company.
When you rinse the equipment often and keep it
clear from grease you ensure the equipments
possibility to grab the bones. The way you hold
and move the machine affects the result of how
the bones are pulled out.
This users manual give you advice on how to avoid
broken or left bones and gapping.

EXOS MINI SPECIFICATIONS
Weight, handle 300gr
Effect 55W
Voltage 100 – 240 V AC
Frequency 50 – 60 Hz
Motor, brushless 12V DC
Fixed speed 150 rpm
Cable length, handle to outlet 1,5 m

Watch out!
• Never put your fingers close to the drums while
working

Placing the fillet right
• In order to work most efficient, place
the fillet with its head closest to you
• You can then push or hold back the
equipment with little risk of imbalance

Raising the bones
• Use the bone guide holder if you want to
put up the end of the bones
• Slant the machine so that only the bone
guide holder touches the fish
• Press down and move your hand towards
the tail
• This makes it easier to get hold of the
bones with little pressure on the machine

Placing the machine correct (1)
• Make sure the whole area of the machine touches the
fish
• Press downwords
• Let the machine move by itself over the fillet. Do not
push it forward!
• An uneven preassure can cause an incorrect angle.
Missed bones or gapping may occur
Pressure
Movement, by
the machine

Placing the machine correct (2)
• Make sure the whole area of the machine touches the
fish and press while moving the machine over the
fish
• Twisting the machine forward or backward may
cause gapping or missed bones
Movement

Placing the machine correct (3)
• Always strive to get the drum 90o
towards the bone so you can pull it
out in the same direction as its fitted
in the fish. An incorrect angle may
cause gapping
• Turn the machine clockwise on a left
fillet and anti-clockwise on a right
fillet

Rinsing the equipment regulary
• When the machine is full of bones or grease turn
the machine away from the fish and press the
water device
• If bones are stuck; try flush more often – or – try
flush less often: bones from underneath may
press up the stucked bones

Cleaning the equipment after use
• Use your fingers to remove the drum and bone guide
• Wash the parts and assemble in reverse order
Cleaning the equipment after use
• Use your fingers to remove the drum and bone guide
• Wash the parts and assemble in reverse order

Spare part list

As manufacturer, we declare that the equipment
follows the provision of the directives stated below:
1 Manufacturer
Exos AB
Ekeby Bruk
SE-752 75 Uppsala
SWEDEN
2 Type of equipment
Pin Bone Remover
3 EC-directive applied to the product
- MD 98/37/EC
-93/68EEG
-EN/IEC61000-6-2 Ed2
-EN55011 (Group I, Class B)
-EN 61000-6-4:2001
Manufactures declaration of conformity

Exos AB, Uppsala, Sweden
WWW.EXOS.SE