F&F ZI-USB-5 User manual

- 1 -
ZI-USB-5
USB power supply
The ZI-USB-5 is used to power electrical and electronic devices
via the standard A-type USB output.
1.Turn off the power.
2.Connect the power cables to the input terminals 1-3 of the
power supply in accordance with the markings: 1 (+) and 3 (–).
3.Connect the cable with the USB A plug to the socket located at
the bottom of the module.
Purpose
Mounting
F&F Filipowski sp. j.
Konstantynowska 79/81, 95-200 Pabianice, POLAND
phone/fax [phone]
www.fif.com.pl; e-mail: [e-mail]
Do not dispose of this device in the trash along with other waste!
According to the Law on Waste, electro coming from households free of charge and can
give any amount to up to that end point of collec� on, as well as to store the occasion of
the purchase of new equipment (in accordance with the principle of old-for-new, regard-
less of brand). Electro thrown in the trash or abandoned in nature, pose a threat to the
environment and human health.

- 2 -
Connection diagram

- 3 -
input voltage 12÷40 V DC
output voltage 5 V DC
output current 2.1 A
output power 10.5 W
current limitation Imax=110% Iout
load minimum 0%
terminal 2.5 mm² screw termnals
tightening torque 0.4 Nm
output USB port
working temperature 0÷40°C
dimensions 1 module (18 mm)
mounting on TH-35 rail
protection level IP20
F&F products are covered by a 24-month warranty from the date
of purchase. The warranty is only valid with proof of purchase.
Contact your dealer or contact us directly.
F&F Filipowski sp. j. declares that the device is in conformity
with the essential requirements of The Low Voltage Directive
(LVD) 2014/35/EU and the Electromagnetic Compatibility (EMC)
Directive 2014/30/UE.
The CE Declaration of Conformity, along with the references to
the standards in relation to which conformity is declared, can be
found at www.fif.com.pl from the product subpage.
Technical data
Warranty
CE declaration
E201109