5
Revision date: 02.11.15
#113133 FodderPro 3.0 Seed Spreader Extension Handle
The 113133 extension handle, when attached to the 113132 hand-held seed spreader, allows you to spread seed in a fodder channel without removing the
channel from the fodder frame. If the 113133 FodderPro 3.0 Seed Spreader Extension Handle was purchased to convert the hand-held spreader, complete the
steps below to attach handle. If extension handle was not purchased, skip this section. Pliers and wrenches (7/16" and 1/2") are required to attach handle.
1. Loosen wing nuts on 1/4" bolts and remove
the handle from seed spreader.
4. Locate handle clevis pin, two (2) flat washers,
and cotter pin removed in Step 2.
2. Remove mounting bracket from 113133
extension handle and set handle aside.
5. Place handle in place and slide clevis pin
through bracket. Insert one flat washer
between handle bracket and mounting bracket
attached to seed spreader.
3. Using the 1/4" fasteners from Step 1, attach
mounting bracket to seed spreader. Hold bolt
heads using a 7/16" wrench while tightening
wing nuts if necessary.
6. Align pin with bracket holes and insert
remaining flat washer between brackets as pin
slides into place. Secure using cotter pin.
ATTENTION: Install flat washers between
brackets.
Use a pliers to bend
cotter pin to secure
clevis pin.
