Fashion Sewing Cabinets Of America 97 User manual

Model 97/98
Please check all table parts for defects before discarding any packing material.
List of Hardware
6- Hinges
36- Flat Head Screws
16- Pan Head Screws
26- Wooden Dowels
4- Brackets
12- Cam Locks
12- Cam Screws
10- 2” Truss Head Bolts
10- Cross Nuts
6- -Casters (4 Locking, 2 Non-
Locking)
6- Caster Screws
List of Parts
1- Top
2- Leaves
2- Top End Supports
4- Wooden Legs
2- Metal Legs
1- Shelf
2- Shelf End Supports
1- Shelf Center Support
List of Tools Needed
Phillips Screwdriver
Flat Head Screwdriver
Hammer
Allen Wrench
Begin assembly.
1.Lay the Top face down on a carpeted floor or
other soft flat surface. The pre-drilled holes
should all be showing. Place 10 Cam Screws and
4 Wooden Dowels in the holes as indicated. You
may need to tap the Wooden Dowels in with a
Hammer.
2. Put 2 Cam Locks and 3 Wooden dowels into each Wooden Leg. When placing Cam Locks, make sure the
small arrow points outward in the direction of the hole.

3. Put 1 Cam Lock and 2 Cross Nuts into each Top End Support. Important: Make sure that the holes are lined
up to recei e the Bolts.
4. Put 2 Cross Nuts and 2 Wooden Dowels into each Shelf End Support.
5. Put 2 Cam Locks and 2 Cross Nuts into the Shelf Center Support.
6. Put 6 Wooden Dowels into the Shelf. Screw 2 Cam Screws into the Shelf with a Phillips Screwdriver.
7. Observe the Wooden Legs. Two of them have eight small holes and the other two do not.

8. With the eight holes facing down put the Wooden leg on the floor. Slide the Top End Support onto the
Wooden Dowel. Slide the Shelf End Support onto the two Wooden Dowels. Put the other Wooden Leg on top.
Insert a two inch Bolt into the Top End Support and the Shelf End Support as shown in the diagram. Tighten
with a Flat Head Screwdriver. If the Bolt will not thread the Cross Nut may need to be realigned. Repeat this
process with the remaining Wooden Legs and Supports.
9. Slide the Shelf Center Support onto the two Wooden Dowels on the Shelf End Support. Insert a two inch
Bolt and tighten with a Flat Head Screwdriver. Repeat this process for the other side.
10. Put the Shelf in place with the Cam Screws and Wooden Dowels facing down. Tighten the two Cam Locks
with a Phillips Screwdriver by turning clockwise 180 degrees.

11. Flip the assembly upside down and place it on top of the Top lining up all of the Wooden Dowels and Cam
Screws. Tighten the 10 Cam Locks that attach the Top to this assembly with a Phillips Screwdriver.
12. Attach the Leaves to the Top by lining up the hinges with the pre-drilled holes. se the 36 Flat Head Screws
provided and tighten with a Phillips Screwdriver.
13. Attach the Metal Legs with the Brackets and the Pan Head Screws using a Phillips Screwdriver. Do not
use a power drill. Put each Screw in half way before tightening them.
14. Attach the -Casters putting the Caster Screws through the non-threaded hole first. Put the Locking
-Casters where you prefer. Tighten with a Phillips Screwdriver.
15. se a helper to turn the table right side up.