Fbt MAD4 IP User manual

I
UK

UK

If the unit is rack-mounted, the rack cabinet shall comply with all the requirements set forth by Standard EN 60439-1, more
specifically the rear side must be closed by an appropriate panel.
- Before connecting the device, make sure the rating matches that of the distribution network.
- The manufacturer accepts no responsibilities for damages resulting from misuse or wrong and unreasonable use.
- Disconnect the device from the mains before any cleaning or maintenance operation.
- In case of failure and/or malfunction, disconnect the device from the mains and do not tamper with it
-Always use original parts
- Only qualified and trained personnel should install, program, start up and service the product, in full respect of the regulations
in force, including those for accident prevention.
- Work in a well-lighted and healthy environment and use instruments, tools and equipment in good working order
-Always check that both the device and the whole system work properly after installation
- Do not install the device outdoor or in places where it is subject to water springs and splashes
- Handle the device with care; it contains fragile and moisture-sensitive electronic components.
- The electrical system must comply with the regulations in force in the country of installation
- Failure to comply with the above may compromise the safety of the device
- The installation engineer must ensure that user information duly appears on the devices, if required
- Components must be disposed of in compliance with the regulations in force
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
!
ATTENZIONE
|
|
|
<
!
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
|
|
|
<
WHERE MARKED, THIS SYMBOL INDICATES A DANGEROUS
NON-ISOLATED VOLTAGE INSIDE.
SUCH VOLTAGE COULD BE SUFFICIENT TO RESULT IN THE
RISK OF ELECTRIC SHOCK.
|
|
|
<
|
|
|
<
WHERE MARKED, THIS SYMBOL INDICATES IMPORTANT
USAGE AND MAINTENANCE INSTRUCTIONS IN THE
ENCLOSED DOCUMENTS. PLEASE REFER TO THE
MANUAL.
!
!
IMPORTANT SAFETY INSTRUCTIONS
The MAD4 IP system transmits audio streams over Ethernet cable even on an already existing network.
If network traffic is very high, we recommend using a separate network to build the system because it could work
discontinuously due to excessive traffic. Alternatively, use a router that will route traffic only to where MAD devices
are connected.
Temporary disturbances may affect the audio output; this is normal when much information travels on the network.
The streaming technology causes a delay of at least 2 seconds between audio sources and their destinations.
When you change an audio source in a module you will have an initial delay of at least 10 seconds due to the
synchronization algorithm between sources and destinations.
Both delays will increase depending on the complexity of the network and of the data traffic in the line.
IMPORTANT
1

2

3
Available sources

4

volume
microphone
5

6
IN
OUT
OUT
6

c:\media\mp3 non trovata
7
Notices
Loads
No load limit defined
Devices state
Alarms state
Multimedia folders
Not enabled
Not initialized

8

9