feather&black Provence Series User manual

Step By Step Assembly Instructions
Page 1
PRE-ASSEMBLY PREPARATION
1. Please check the part contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact the retailer from
whom you bought this product.
2. This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE
CARE WHEN LIFTING to avoid personal injury and (or) damage to the product.
3. This product takes approximately 60 MINUTES to assemble with 2PEOPLE.
4. The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG
CHILDREN.
5. Read this leaflet in full before commencing assembly.
6. You will require a cross head screwdriver (not provided) and a spanner (provided) to assemble this
product.
Provence Collection
Universal Assembly Instruction
135cm Double Bed
150cm King Size Bed
180cm Super King Size Bed

Panel and Fittings Identification
Item Description Qty. Item Description Qty. Item Description Qty.
A1
Headboard B1 Footboard C2
Side Rail
D1
Centre Rail ESlat F8
G2
12mm Spanner H8
Flat Washer I8
Spring Washer
J10 KL2
Bracket
M12 N2O2
Flat Washer
P
Page 2
Dowel
C
A
B
C
135cm 32
150cm/180cm 34
Slats cap
135cm 64
150cm/180cm 68

Page 3
Step 1
Step 2-Locate the side rails (C) onto the dowels (P) and threads (F) protruding from
the headboard (A) and footboard (B). Locate the washer (H & I) and nut (J)
onto the threads (F) and secure by hand at first. Tighten using the open ended
spanner (G) (provided).
F x 8
H x 8
I x 8
J x 8
Please note:
The hole in the slat support rail
should be facing upwards.
Spanner, G
H, I, J
-Insert four wooden dowels (P) into the headboard (A) and footboard (B). This
will assist in the alignment of the side rail. Screw the eight threads (F) into the
headboard (A) and footboard (B) and tighten by hand. Ensuring that there is
enough thread remaining for attachment in Step 2.
F
G x 1
B
C
C
A
B

Page 4
Step 3-Attach the brackets (L) to the headboard and footboard using the screws (M)
inserted into the pre-drilled pilot holes. Tighten using a cross head
screwdriver (Not provided).
L x 2
M x 12
Step 4-Locate the centre rail (D) into the brackets. Secure using the remaining
nuts (J), flat washers (O) and bolts (N). Tighten using two spanners (G).
L
M
N x 2
O x 2
J x 2
N
G
OJG
Please note
The holes in the centre rail
should be facing upwards.
G x 2
Crosshead
screwdriver
(Not provided)
C
C
A
B
D
C
C
A
B

Page 5
Step 5-Push fit two plastic caps (K) onto either end of each slat (E). Push fit the slat
(E) into the pre-drilled pilot holes. Please note that the slat may need to be
pushed flat to ease installation. It may also require a light tap with a soft
hammer to secure the plastic end caps into the holes. Repeat this step with
the other slats (E).
The assembly is now complete.
135cm x 64
150cm/180cm x 68 K
E
C
C