
REAR PANEL
M. IEC POWER INLET: Connect included power cord to a grounded
outlet in accordance with input power voltage and frequency
specied beside inlet. Universal 100V-240V operation.
N. POWER: Turns amplier on and o.
O. MUTE: Mutes power amp. When in MUTE mode, XLR line output
remains active for studio or “quiet stage” use, and POWER JEWEL
(L) illumination changes from red to amber.
P. OUTPUT POWER
: Selector switch oers full power (22 watts) and
ve other attenuated wattage settings that tailor room/venue
overall loudness. Set amp front-panel channel volume to personal
preference for tube-emulated response, then set OUTPUT POWER
to preferred level.
CABINET SIM: When using XLR BALANCED LINE OUTPUT (T), this
switch oers three dierent tonal options—a at, uncolored amp
signal without speaker cabinet emulation (OFF); and two impulse
response (IR) proles emulating dierent speaker/microphone-
placement combinations:
IR PROFILE 1: Dynamic microphone close-mic’ed at edge of
speaker cone center cap for pronounced attack and denition. IR
created using a Shure® SM57 microphone.
IR PROFILE 2: Dynamic microphone close-mic’ed at edge
of speaker cone center cap for increased bass response and
smoother midrange. IR created using a Sennheiser® MD 421
microphone.
Q. BALANCED LINE OUTPUT LEVEL: Adjusts output level of XLR
BALANCED LINE OUTPUT (T) for external devices and systems (i.e.,
PA and recording gear), whether mic or line level.
R. GROUND LIFT: When using the XLR BALANCED LINE OUTPUT (T),
engaging this button may eliminate hum or buzz resulting from
connection to improperly grounded equipment.
S. XLR BALANCED LINE OUTPUT: For balanced connection to
external devices and systems (i.e., PA systems and recording gear).
XLR line output remains active when amp is in MUTE mode (O).
T. FOOTSWITCH: Connect included two-button footswitch for
reverb and tremolo on/o here.
U. USB PORT (NOT SHOWN): For rmware updates, a USB port is
located on the underside of the chassis beneath the OUTPUT
POWER section. Visit fender.com/rmware/support for periodic
rmware updates that improve and enhance the Tone Master
experience.
All non-FMIC product names and trademarks appearing in this
manual are the property of their respective owners and are used
solely to identify the products whose sounds were studied during
IR development for this product. The use of these products and
trademarks does not imply any aliation, connection, sponsorship,
or approval between FMIC and with or by any third party.
SPECIFICATIONS
TYPE PR 5185
POWER REQUIREMENTS 300W (max)
POWER AMP OUTPUT
100W into
8
Ω (simulates 22W tube amp performance)
INPUT IMPEDANCES Input 1 (both channels): 1M
Ω
Input 2 (both channels): 136k
Ω
XLR LINE OUT IMPEDANCE 600
Ω
SPEAKER 1 12” Celestion® G12 NEO Creamback, 8
Ω (PN 7713555000)
FOOTSWITCH Two-button Tone Master (included, PN 7716005000)
COVER Fitted cover (included, PN 0047483000)
DIMENSIONS AND WEIGHT Width: 24.1” (61.3 cm) Height: 17” (43.4 cm) Depth: 9.28” (23.6 cm) Weight: 23 lbs. (10.4 kg)
Product specifications subject to change without notice.
ENGLISH
2