FENGJU FRVS Series User manual

FENGJU | Innovave Signage Lighng | www.led-tech.com | Page 1
Components
1) 3x1.5mm²Power Cable
2) Wire connectors
3) #6 (M3) screws
4) 24V Power Supply
5) Electronic grade silicone
RISK OF ELECTRIC SHOCK
Turn power off before inspection, installation or removal.
Properly ground power supply enclosure.
RISK OF FIRE
Use only UL certified wire for input/output connections. Minimum size 16 AWG (1.5mm²).
Follow all NEC and local codes.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
Prepare Electrical Wiring
Electrical Requirements
• Limited to use in dry and damp locations.
• The grounding and bonding of the LED Driver shall be done in accordance with
National Electric Code (NEC) .
• Follow all National Electric Codes (NEC) and local codes.
Layout Recommendations
Channel
Depth
(in.)
Single Row Multiple Rows Channel
Depth
(mm)
Single Row Multiple Rows
Max.
Stroke
Module
Spacing
Row
Spacing
Module
Spacing
Max.
Stroke
Module
Spacing
Row
Spacing
Module
Spacing
48310 3100 200 75 100 75
59310 3125 225 75 100 75
610 410 4150 250 100 100 100
711 410 4175 275 100 100 100
≥712 410 4≥200 300 100 100 100
*Density guide designed to maintain a minimum of 600 lux for a single row or 800 lux for multiple
rows at sign face .
FRVS Series Installation Guide

FENGJU | Innovave Signage Lighng | www.led-tech.com | Page 2
Layout Modules
Clean & remove all debris from
the inside of the Light box before
you begin.
❶
❸
Measure and cut FRVS LED strip to the
appropriate length for each Light box .
Cuts can be made between any of the
❷
❹
Use screws to secure at every FRVS
LED module within the Light box. Use
#6 (M3) pan headed metal screws.
Drill a 10 mm hole near the FRVS LED
strip and grommet the hole for supply
wire access.
Electrical Connections
Wiring Diagram
❶Run a wire from the Power Supply and DMX
Decoder to each Light box and connect to the
first LED module on the strip.
Must be used with 24 Volt Power Supplies.
❷
❸
❹
Connection follow wiring diagram instruc-
tions. Connect LED strips using twist-on
wire connectors.
NOTE: All electrical connections should
be made within the Light box.
Must apply electrical grade silicone to
exposed wires.
❸Clean & remove all debris from the inside of the Light box.
LED
Red 24V (+) Black 24V (-)
Driver
LED
DMX
D+
D-
ADI
TO LED
FRVS Series Installation Guide
From Driver &
DMX Signal
Black (24V-)
Red (24V+)
DMX IN
DMX
Interface/Decoder
Green(D+)
Blue (D-)
White (ADI)
Driver
L
N
110~265V AC
Red (24V+)
Black (24V-)