FENGJU FLL Series User manual

FENGJU | Innovave Signage Lighng | www.led-tech.com | Page 1
Components
1) 3x1.5mm²Power Cable
2) Wire connectors
3) #6 (M3) screws
4) 24V Power Supply
5) Electronic grade silicone
RISK OF ELECTRIC SHOCK
Turn power off before inspection, installation or removal.
Properly ground power supply enclosure.
RISK OF FIRE
Use only UL certified wire for input/output connections. Minimum size 16 AWG (1.5mm²).
Follow all NEC and local codes.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
Prepare Electrical Wiring
Electrical Requirements
• Limited to use in dry and damp locations.
• The grounding and bonding of the LED Driver shall be done in accordance with
National Electric Code (NEC) .
• Follow all National Electric Codes (NEC) and local codes.
Layout Recommendations
Channel
Depth
(in.)
Single Row Multiple Rows Channel
Depth
(mm)
Single Row Multiple Rows
Max.
Stroke
Module
Spacing
Row
Spacing
Module
Spacing
Max.
Stroke
Module
Spacing
Row
Spacing
Module
Spacing
48626100 200 150 150 50
59626125 225 150 150 50
610 737150 250 175 175 75
711 737175 275 175 175 75
≥712 737≥200 300 175 175 75
*Density guide designed to maintain a minimum of 600 lux for a single row or 800 lux for multiple
rows at sign face .
FLL Series Installation Guide

FENGJU | Innovave Signage Lighng | www.led-tech.com | Page 2
Layout Modules
Clean & remove all debris from
the inside of the Light box before
you begin.
❶
❸
Measure and cut FLL LED strip to the ap-
propriate length for each Light box . Cuts
can be made between any of the modules.
❷
❹
Remove tape backing and stick FLL LED
modules into place. Continue until you
have reached the end of the strip.
Drill a 10 mm hole near the FLL LED
strip and grommet the hole for supply
wire access.
Electrical Connections
Wiring Diagram
❶Run a wire from the Power Supply and DMX
Decoder to each Light box and connect to the
first LED module on the strip.
Must be used with 24 Volt Power Supplies.
❷
❸
❹
Connection follow wiring diagram instruc-
tions. Connect LED strips using twist-on
wire connectors.
NOTE: All electrical connections should
be made within the Light box.
Must apply electrical grade silicone to
exposed wires.
❸Clean & remove all debris from the inside of the Light box.
LED
Red 24V (+) Black 24V (-)
Driver
LED
DMX
D+
D-
ADI
TO LED
FLL Series Installation Guide
White (24V-)
White/Red (24V+)
DMX IN
DMX
Interface/Decoder
Green(D+)
Blue (D-)
Yellow (ADI)
Driver
L
N
110~265V AC
Red (24V+)
Black (24V-)
From Driver &
DMX Signal