Ballard Designs KENNEDY LL321 User manual

Customer Service: 800-367-2810
Online: www.ballarddesigns.com
PRODUCT NAME: KENNEDY FLOOR LAMP BASE
ITEM NUMBER: LL321
DIMENSIONS OF ITEM ASSEMBLED: 66 1/8”H x 20 3/4”DIA
`
IMPORTANT SAFETY INSTRUCTIONS:
-The Lamp has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of
electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fully fit in the
outlet,reverse the plug. If it still does not fit,contact a qualified electrician. Never use with an
extension cord unless plug can be fully inserted. Do not alter the plug.
-These Assembly Instructions are provided for your safety. It is important that they are read carefully
and completely before assembling this Lamp.
-This product must be installed with the applicable installation code by a person familiar with the
construction and operation of the product.
-This Fixture has been rated for up to 100 Watt MAX Type A Bulb (NOT Included) or 25 Watt CFL
Bulb (NOT Included) .
WARNING:
-Deviation from the Assembly Instructions may result in a risk of fire or electric shock.
-To reduce risk of fire, electrical shock, or personal injury, always turn off Fixture and allow
it to cool prior to replacing the bulb.
-Do not touch the bulb when the Lamp is turned on. Do not look directly at the lit bulb.
-Keep flammable material away from the lit bulb.
PRODUCTS ARE NOT INTENDED MADE IN CHINA
FOR COMMERCIAL USE. Page 1 of 3

NOTE: Remove all parts and hardware from the box along
with any plastic protective packaging and carefully lay all the parts
out on a clean, flat surface.
DO NOT discard any contents until after assembly and
installation is complete to avoid accidently discarding small
parts or hardware.
Recommended Location for Use: Dry Indoor Environment
Assembly Time: 5 Minutes
People Required: one person
PARTS
Check to make sure you have the following:
INCLUDED:
NOT INCLUDED:
1-100 Watt Max Type A Bulb
Page 2 of 3
1‐LampBase(A)

LampBase
1‐Harp (C)
Harp
1‐Finial (B)
1‐Rubber Ring (D)

STEP 1:
Squeeze the Harp (C) ends into the Saddle of the
Lamp Body (A).
Place the Shade (not included) over the Harp (C) top
Secure it on top by screwing on the Finial (B) and
Rubber Ring (D) until it is snug.
STEP 2:
Screw in bulb. This Lamp has been rated for up
to a 100 Watt MAX type A bulb or 25 Watt CFL bulb
(NOT INCLUDED).
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Page 3 of 3
(A)
(D)
Cleaning & Care:
To clean, wipe the Fixture with a soft, dry cloth.
Avoid the use of harsh or abrasive
chemicals as they may damage the finish
(C)
(B)