
TO USE FIREFLY® PLAY ACTION™ TOOTHBRUSH
1. Wet brush head and apply toothpaste
2. Press Gem Button to turn on and start brushing
3. Toothbrush will gently vibrate as music plays and ring lights up
4.
Poppy
&
friends provide a guided brushing experience starting with zone 1, until all
4
zones
of the mouth are complete (zones are approximately 30 seconds each)
5. During guided brushing session, child receives Trolls themed messages and encouragement,
e.g.,
"
Zone 1 complete
;
Move your brush to the opposite side on top
;
Music is life!
"
6. Press Up/Down Arrows to play bonus sound effects
7. Upon completing all
4-
zones, a surprise is unlocked.
"
Press the Gem Button to unlock your
surprise!
"
8. Once Gem Button is pressed, it unlocks the next adventure
with a Trolls themed reminder,
"
Play your new adventure next time you brush.
"
9. Once each level has been unlocked, the preferred adventure can be selected with
the Up/Down Arrows
✓
PRACTIC E MODE -FOR FIRST TIME
1. There will be a vocal prompt to press Gem On/Off Button to begin brushing in
practice mode
2. Once complete, use Up/Down Arrows to select color of Gem, then press Gem On/Off
Button to begin new brushing session
TO ATTACH AND REMOVE THE TOOTHBRUSH HEAD
1. To attach brush head, align dot on back of head with the arrow on top of handle
2. Firmly place brush head onto handle and twist clockwise until dots on both handle and brush
head are aligned
3. To remove brush head, twist brush head counterclockwise until dot on the back of the head
aligns with the arrow on the top of the handle and pull straight
TO REMOVE AND CHANGE THE BATTERY
1. To access the battery compartment, locate screw on the back of handle and remove using a
small Phillips head screwdriver with a counterclockwise motion
2. Gently pull down on the red plastic cap to access inside of battery compartment
3. Remove each battery from inside and recycle according to local requirements
. Replace Alkaline AAA batteries with new of the same type (do not mix old and new batteries)
and note the batteries direction according to the battery symbol
4.
Replace red plastic cap, ensuring parts are aligned with the screw hole on the back of the
handle.
S
crew hold should be visible and parts firmly secured
5. Replace the screw using a clockwise motion until screw head is flush with the handle being
careful to not apply excessive force