firewood 5 User manual

+
_
o-ring
notches
o-ring
notches
5
IMPORTANT SAFETY INSTRUCTIONS
MISUSE CAN CAUSE INJURY AND PROPERTY DAMAGE!
Read instructions be ore use and only use vaporizer
according to instructions.
• Only use with High Drain Lithium Ion 18650 cells that
are rated or a minimum of 20 Amps continuous
dischar e current and have a nominal voltage o 3.7V.
See the Firewood website or speci ic recommendations.
• Never use a battery that has been damaged or that has
a damaged plastic covering.
• Only use a battery charger that is intended or use with
18650 cells and has over-charge circuit protections.
• Remove battery when traveling by air or sending by
mail.
• Do not use near
water or i wet.
• The tray can get
HOT while in use.
Please use caution
and allow a ew
minutes or the tray
to cool be ore
handling.
Remove Mouthpiece/Battery Cover
Pinch and li t then slide out:
Load Battery
Insert the negative terminal irst.
Push down against the spring and
slide the positive terminal into place.
I the battery is inserted the wrong
way the vaporizer will buzz
continuously – remove the battery
immediately and ix
Put the Mouthpiece/Battery Cover
back on ensuring it snaps into place
Remove Tray
Careful – Ceramic Tray Can Break if Dropped!
Grind Plant Material
and Fill Tray
Slide Tray Into
Vaporizer:
Select the Chamber:
Push the tray all the way in, or align so that the o-ring is
centered between the notches on the tray.
Check Battery Level:
Click the button once
quickly. The vaporizer
will buzz between 1 and
5 times to indicate the
battery level. 3 sets o
3 buzzes indicates the
charge level is too low
to use (<3.5V) Recharge immediately to prevent battery
damage! 3 sets o 4 buzzes indicates the charge level is too
high (>4.3V), please check charger!
Buzzes Battery Level
5 High (above 4.1V)
4 Medium-High (3.95V - 4.1V)
3 Medium (3.8V – 3.95V)
2 Medium-Low (3.7V – 3.8V)
1 Low (below 3.7V)

Glass Tube
L Joint
Tubular Tube
Tray
1/2" SS Screens
Set Heat Level - Click the button 2, 3 or 4 times:
# Clicks Heat Level Capsule Tar et Temp Ran e
2 low 250º - 350º F (121º – 177º C)
3 medium 350º - 400º F (177º – 204º C)
4 high 400º - 450º F (204º – 232º C)
The vaporizer will pause or a moment then buzz between 2
and 4 times to con irm your selected level. Click the button 5
times to get the currently stored heat level.
Hold Button and Draw - The vaporizer will buzz as it starts
to heat up. You can start to draw as soon as it buzzes or wait
a ew seconds or the heater to warm up. The vaporizer will
buzz rapidly i you are drawing too ast. Release the button
when done with each draw. Continue to take draws until the
vapor thins out and/or tastes cooked. The vaporizer will give
a power down buzz within a ew seconds o releasing the
button a ter each draw.
Cleanin - The Tray,
Glass Tube, Tubular
Tube, and L joint need
to be cleaned
periodically.
Clearing the tray
immediately a ter
each use will help
keep the tray clean (blow on screen side o tray to quickly
remove contents while still warm). To thoroughly clean the
tray, irst remove the screens and soak in alcohol, burn clean,
or replace with 1/2” SS pipe sreens. Then clean the tray with
isopropyl alcohol. Push the screens back into place when
done. Remove the Glass Tube by sliding it out rom the
Battery Cover/Mouthpiece then remove the L joint. Clean
both with isopropyl alcohol and/or a pipe cleaner.
Use the Wooden Tool to push
the Tubular Tube down as
shown, then use the tool to
pull the oring/Tubular Tube out
o the bottom o the vaporizer.
Clean with isopropyl alcohol.
To re-assemble, start by putting the top two o-rings into place
beneath the heater. Use the wooden tool to ensure they lay
lat. Slide the tray all the way into place, turn the vape over,
then push the Tubular Tube into the hole so that the 3 holes
in the Tube are on the bottom side o the vaporizer. Push the
inal o-ring down around the Tubular Tube.
Adjustin Heat Level Settin s:
Each o the three heat levels can be adjusted up or down to suit the user's
pre erences. Click the button 8 times to enter options mode, then click 2, 3, or 4
times to select the heat level to adjust. Finally click to adjust the level based on
the table below. Skip the inal step to restore the selected heat level to the
de ault.
Adusted Heat Level Based on Number of Clicks:
Ori inal
Level ↓
1 click
(+¼)
2 clicks
(+½)
3 clicks
(+¾)
4 clicks
(+1)
5 clicks
(-¼)
6 clicks
(-½)
7 clicks
(-¾)
2, low 2¼ 2½ 2¾ 3 1¾ 1½ 1¼
3, med 3¼ 3½ 3¾ 4 2¾ 2½ 2¼
4, high 4¼ 4½ 4¾ 5 3¾ 3½ 3¼
Finishin & Maintainin the Wood Surface: Firewood vaporizers come either
un inished or with a 100% natural Tung Oil inish. For best results, un inished
wood should be sanded and inished with a natural oil/wax inish. Finished wood
can be restored by lightly sanding and reapplying a resh oat o the original inish.
Warranty: Firewood Vaporizers Inc. One (1) Year Limited Warranty In ormation
Firewood Vaporizers Inc. grants purchasers o the Firewood Vaporizer a warranty
against de ects in materials and workmanship under normal use o the device or
a period o one (1) year rom the date o retail purchase by the original purchaser
o the unit. I a physical de ect arises and a claim is received within the Warranty
Period Firewood Vaporizer Inc. will either (1) repair the device, (2) exchange the
device, or (3) re und the purchase price o the device, at the discretion o the
company.
Exclusions and Limitations :
The Limited Warranty applies only to devices manu actured by Firewood
Vaporizer Inc. This warranty does not apply to: (a) to damage caused by accident,
abuse, misuse, or other external causes; (b) to damage caused by operating the
device outside the permitted or intended uses; (c) to a device or part that has
been modi ied to alter unctionality or capability; (d) to cosmetic damage,
including but not limited to scratches, dents, and discolored wood; (e) to damage
caused by use o unapproved batteries, charger or power supply; ( ) damage to
ceramic parts a ter 1 month rom the purchase date.
The Warranty does not apply to normal per ormance degradation o batteries,
neglecting to adhere to cleaning instructions, or heat damage due to improper use
o the device. Intentionally disassembling or attempting repairs on your device will
void the warranty.
Please email service@ irewoodvapes.com or warranty service. Please include a
description o the problem and the Name and Date o purchase.