Firstech Aqua Bed AB-BLE-550 User manual
FCC / IC Compliance
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this device.
This equipment should be installed and operated with minimum 20 cm between the radiator and your
body.
IC
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
Cet appareil doit être installé et utilisé avec un minimum de 20 cm entre le radiateur et votre corps.
Table of Contents
Welcome ....................................................................................................................... 03
USB Connector .................................................................................................. 03
Important Safety Precautions ............................................................................. 04
Standard Components ........................................................................................... 05
Getting Started ........................................................................................................... 05
Initial Setup ............................................................................................................. 05
System Operation ..................................................................................................... 06
Temperature Units (Fahrenheit/Celsius) ...................................................................... 07
Setting Operating Time .................................................................................................... 07
Time Options ......................................................................................................... 07
Setting Operating Temperature ......................................................................... 08
Temperature Options ......................................................................................... 08
Safety Features ...................................................................................................... 08
Cleaning and Storage ............................................................................................. 09
Water Replacement ............................................................................................ 09
Troubleshooting ........................................................................................................ 09
Error Codes ............................................................................................................ 09
Product Registration .......................................................................................... 10
Warranty Policy ..................................................................................................... 10
Aqua BedWarmer Support .................................................................................. 11
Welcome
The Aqua Bed Warmer provides outstanding comfort by adding warmth to
your night's rest. Find relaxation with your Aqua Bed Warmer using the water
you already have at home. The Aqua Bed Warmer utilizes a system of sturdy
tubing that distributes heated water evenly throughout the connected pad.
With a wide range of temperature selections, the bed warmer offers control
over the level of warmth at your disposal.
USB connector
ATTENTION
This unit features a USB connector. This unit is not for a PC product.
To reduce damage to this product, do not attempt to insert the USB connector
into Personal Computer.
Do not attempt to modify the USB connector.
Serious damage to the appliance and household electrical system can occur.
Important Safety Precautions
1. Carefully read all instructions before handling product.
2. Do not handle system when hands are wet.
3. Do not immerse system or any system component in water.
4. Plug the USB connector in an aqua bed warmer controller only.
5. Do not pull the cord at the USB cable, pull at the grip.
6. Do not operate with damaged cord or any other damaged component(s).
7. Take off the product when cleaning and/or replacing unit water.
8. Do not place sharp objects near any component.
9. Shutoff the system immediately if any water is found near any component.
10.Use the system indoors only.
11.Place unit on firm, flat surface.
12.Do not move unit around electrical systems.
13.Keep away from children.
Getting Started
Before First Use
1. Read and review all safety information and product guidelines.
2. Inspect all product components for factory defects.
3. Dispose of product packaging components properly.
Initial Setup
1. Turn off the Aqua Bed Warmer Controller
2. Connect the usb cable to the USB connector at the rear of the Aqua Bed Warmer
Controller.
3. Connect the usb cable to the USB connector at the rear of AB-BLE-550.
4. Attach the AB-BLE-550 to the back of the Aqua Bed Warmer Controller.
5. Turn on the Aqua Bed Warmer Controller
System Operation
Temperature Units (Fahrenheit/Celsius)
1. To change the unit of
temperature on the display,
press the POWER button to
deactivate the system.
2. Press Settings.
3. Press TEMP to switch
between degrees Fahren-heit
or Celsius.
4. Press Save and POWER to
reactivate the system.
Setting Operating Time
1. With the unit ON, the display will indicate the
current temperature of the system.
2. To view the set operating time, press TIME.
The display will indicate the number of hours
the system will continue to operate at the set
temperature.
3. To change the operating time, press TIME
until the projected operating time is
displayed and then the UP or DOWN arrows until the desired number of hours is
reached.
Time Options
Minimum
Default
Maximum
1 Hour
8 Hours
24 Hours
Setting Operating Temperature
1. With the unit ON, the display will indicate the
current temperature of the system.
2. To view the set operating temperature, press
TEMP. The display will indicate the projected
temperature in either Fahrenheit or Celsius,
according to the current setting.
3. To change the operating temperature, press
TEMP until the projected operating
temperature is displayed and then the UP or
DOWN arrows until the desired temperature is
reached.
Temperature Options
Minimum
Default
Maximum
50 ℉
( 10 ℃)
90 ℉
( 32 ℃)
158 ℉
( 70 ℃)
Safety Features
1. Automatic shut-off when the unit is tipped over
2. Display indicates when the water level has reached full level.
3. System automatically indicates when internal temperature falls below 39 ℉to prevent
freezing.
Cleaning and Storage
Cleaning
1. Clean the appliance with a dry cloth.
2. IMPORTANT – Do not wipe the product with wet cloth.
Storage
1. IMPORTANT – Disconnect the power from the unit before removing from the system.
2. Place system directly above a large, open container.
3. Remove the USB cable from the Aqua Bed warmer controller
4. Separate the AB-BLE-550 from the Aqua Bed warmer controller.
Troubleshooting
Error Codes
Code
Description
Troubleshoot
E1
Low Water Level
Insert Water
E2
Temperature Sensor
Contact Support
E3
Circulation Pump
Contact Support
E4
Heater
Contact Support
E5
System Overheat
Contact Support
E6
Water Level Sensor
Contact Support
RF Specification
1. Supported protocols : Bluetooth® Low Energy
2. RF Transmitter Characteristics : 2.4GHz Band, 1 Mbps Data Rate
Product Registration
This product must be registered within 10 days of purchase to validate war -ranty. To register,
complete and return the included warranty registration card or register online at
www.aquabedwarmer.com.
Warranty Policy
Aqua BedWarmer comes with a 2year limited warranty from the date of purchase for the
original owner. The product must be registered within 10 days to validate warranty. If a
defect in the heater unit and/or mat arises, the item(s) may be replaced under warranty.
Unit(s) exhibiting damage and/or evidence of unauthorized modification will be void of
warranty coverage.
Aqua BedWarmer Support
21903 68th Avenue South
Kent, WA USA 98032
Phone: (888) 820-3690 #112
Email: warranty@aqua-bedwarmer.com
Web: www.aqua-bedwarmer.com
Published By
Firstech, LLC
21903 68th Avenue South
Kent, WA 98032U.S.
Tel: 1-888-820-3690
www.aqua-bedwarmer.com
© 2012 Firstech LLC. All rights reserved.
This manual suits for next models
2
Table of contents
