FirstStreet PERFECT WALKER II User manual

Setting up your Perfect Walker II is very simple and best done by following these easy
instructions. You will be using your walker in a few minutes. It is recommend that you
lay out all of the provided components and tools to ensure that you have easy access to
them at each step.
PERFECT WALKER II
UNBOX & SET-UP GUIDE
INTRODUCTION

PERFECT WALKER II UNBOX & SET-UP GUIDE2
Unpack the Perfect Walker II and lay out the
parts for easy access.
STEP 1
STEP 2
STEP 3
STEP 4
Loosen and remove the 4 large thumbwheel
screws from the black lower frame.
Fold out each of the 4 wheel/leg combinations to their full positions, ensuring that the screw holes
are lined up between the frame and the legs.
Insert the 4 thumbwheel screws that were removed in Step 2 into
the 4 holes in the lower legs. The thumbwheel screws are to be
inserted from the exterior side of the frame. The bolts may be
a little tight when inserting into the holes - this is normal. Once
inserted as far as they can go, screw them into place and lock the
wheels into place.
Thumbwheel
(x4)
Unfold the Perfect Walker II so that the seat is locked into
place. Push rmly down on both sides of the seat until you
hear the seat click into its locked position. It will look like
the image below when locked into place.
STEP 5

PERFECT WALKER II UNBOX & SET-UP GUIDE 3
Insert the upper arms (identied with the push pins on one side of
each arm) into the right and left posts. The proper position for each
is with the push pins to the outside and the thumbwheel below the
arm cuffs facing forward.
The push pins on each arm are the way to adjust the arms for an appropriate height. This can be
done as a last step.
Insert the handles into the front of the
arm tubes. You may need to loosen the
thumbwheels under the arms to allow the
handles to be properly inserted into the
arm supports. These are adjustable. Once you have determined the appropriate length, lock the
handles into place by rmly tightening the thumbwheels in the upper arms.
At this step, check all thumbwheels for tightness and that the seat is locked rmly into place. This
ensures that the frame of the walker will remain open during use as well as when sitting in the seat.
STEP 6
STEP 7
STEP 8
Your fully assembled Perfect Walker II will look like this…the
storage bag under the seat attaches to the posts in front of the
seat using the loops on either side of the bag.
The Perfect Walker II is now ready for use. Please use it only
in accordance with its intended use as a device to assist
walking. Please note that the specied user weight may not
exceed 300 pounds and it will only hold one user at a time,
particularly when seated on the walker’s seat.
FULLY ASSEMBLED PERFECT WALKER II

If you have ANY questions, please don’t hesitate to ask - you can contact our Customer
Service Agents Monday through Friday between 9am and 8pm eastern time.
Our toll free number is 800-958-8324.
CUSTOMER SUPPORT
PERFECT WALKER II
UNBOX & SET-UP GUIDE