Fisher & Paykel OR30SDPWIX2 User manual

Setting the Clock
Buttons
/
Sets the timer.
Sets the cooking time.
Sets the stop time for automatic cooking.
Set the oven temperature/ select Celsius or
Fahrenheit
Decreases the time and temperature.
Increases the time and temperature.
Sets the Self Clean time.
Starts the oven/starts the Self Clean cycle. Clock display and Control Buttons
If the Display Shows It Means that... For More Information
flashing 12:00 The clock needs to be set. See instructions below
https://producthelp.fisherpaykel.com/us/Cook/Ranges/Induction/OR30SDPWIX2/User_Guide_OR30SDPWIX2/04_setting_the…
Updated: Mon, 16 Mar 2020 14:14:28 GMT
Powered by
1

If the Display Shows It Means that... For More Information
A
steadily lit The oven is set for automatic
cooking.
See section ‘Automatic cooking’
Automatic cooking has
finished Automatic cooking has finished
steadily lit The timer is set See section ‘Using the electronic
timer’
steadily lit The oven is heating up See section ‘Using your oven’
To Set the Clock
When the power to the appliance is turned on or restored after a power failure 12:00 will flash in the display.
1. Press and together
-
the display will stop flashing. The clock is now set for 12:00.
2. Press
and
together again to change the time. The display will flash
3. Rotate the temperature dial or press
and
to set the time. After a few minutes the display will be steadily lit, showing the time is set.
https://producthelp.fisherpaykel.com/us/Cook/Ranges/Induction/OR30SDPWIX2/User_Guide_OR30SDPWIX2/04_setting_the…
Updated: Mon, 16 Mar 2020 14:14:28 GMT
Powered by
2

To Change the Time
1. Press and together. The display will flash.
2. Rotate the temperature dial or press and to set the time.
After a few seconds the display will remain steadily lit, showing the time is set.
When the indicator light is at the top the time is set for am
When the indicator light is at the bottom the time is set for pm.
https://producthelp.fisherpaykel.com/us/Cook/Ranges/Induction/OR30SDPWIX2/User_Guide_OR30SDPWIX2/04_setting_the…
Updated: Mon, 16 Mar 2020 14:14:28 GMT
Powered by
3