Fisher & Paykel OR90SCG6B1 Guide

Using the Warming Drawer
Use the warming drawer to keep food warm after you have finished cooking and to warm plates before serving. The
warming drawer will keep hot cooked foods at serving temperature.
• Allow time for the drawer to preheat.
• Place hot food in a heatproof pan or serving dish.
• Take care when opening the drawer. Position your hand at the bottom of the drawer and open slowly to allow
hot air and steam to escape.
• Take care not to touch the inside surfaces of the drawer while it is hot.
• When using the drawer to warm plates ensure the temperature is only set to LO. Ensure plates are evenly
spread out.
• Do not stack dishes or plates as this may result in uneven heating.
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SCG6B1/User_Guide_OR90SCG6B1/0…
Updated: Tue, 16 May 2023 00:15:22 GMT
Powered by
1

1. Push in the warmer dial and turn clockwise to
HI.
• While the drawer is on the indicator will
glow red.
2. When you have finished using the drawer turn the dial back to
0 (OFF).
• The indicator will go out.
Warmer Dial
• The temperature can be set anywhere between LO (minimum) and HI (maximum).
• The warming drawer is fitted with an heating element in the top.
• See the below table for the temperature settings.
Dial Position °C
LO 30
Hi 75
• Do not use the drawer to reheat food.
• Do not place food in the drawer in unopened containers. Built up pressure could cause the
container to burst.
• Do not use plastic containers.
• Use dry potholders to transfer dishes to and from the drawer. Take care not to let potholders
touch the hot upper element.
• Do not store flammable items in the drawer.
• Do not use the warmer drawer as a storage drawer.
• Do not use aluminum foil to line the drawer.
• Make sure the dial is always set to O (OFF) when running a self clean cycle and any time when
the drawer is not in use.
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SCG6B1/User_Guide_OR90SCG6B1/0…
Updated: Tue, 16 May 2023 00:15:22 GMT
Powered by
2