Fisher-Price CMR51 User manual

1
CMR51, CMR53
DKR72, DVM43
DYH25
fisher-price.com
Full-Size
Full-Size
High Chair
High Chair
Booster Seat
Booster Seat
SpaceSaver
SpaceSaver
High Chair
High Chair
Youth Chair
Youth Chair
IMPORTANT! Please keep these instructions for future reference.
Adult assembly and setup is required. No tools are needed.

2
Consumer Information
WARNING:
When used as a high chair:
Prevent serious injury or death from falls or sliding out.
• Always use the restraint system.
• Never leave child unattended.
• Use upright position only with a child who is able to sit up unassisted.
• Always leave wheels locked. Never use near steps.
• The tray is not designed to hold the child in the product.
When attached to an adult chair:
Prevent serious injury or death from sliding out, falls, or tipping over.
• Always use the restraint system.
• Use the restraint system until child is able to get in and out of the product without
help (about 2½ years old).
• Never leave child unattended.
• Never allow child to push away from a table.
• Attach this product to an adult chair using bottom and back attachment straps.
• Never use this product on a stool or bench that does not have a seat back.
• Before each use, be sure product is properly secured to an adult chair.
• Use upright position only with a child who is able to sit up unassisted.
• The tray is not designed to hold the child in the product.
• Prevent serious injury or death. Never use in motor vehicles.
IMPORTANT! Before assembly, setup and each use, inspect this product for damaged hardware,
loose joints, missing parts or sharp edges. Do not use the product if any parts are missing,
damaged or broken. Do not use accessories or replacement parts other than those approved by
the manufacturer. Never substitute parts.
•Please read these instructions before assembly and use of this product.
•Maximum weight: 50 lb (23 kg).
•Before use thoroughly wash all parts that may contact food.
•The tray, tray insert, high chair seat and seat back are dishwasher safe. You must remove the
restraint system before placing the seat in the dishwasher.
•The tray and tray insert are not microwave safe.
•The restraint system, frame, youth chair seat and the chair attachment base may be wiped clean
using a mild cleaning solution and a damp cloth.
•The pad is machine washable. Wash in cold water on the gentle cycle. Do not use bleach.
Tumble dry separately on low heat and remove promptly.
•Product features and decorations may vary from images.

3
Parts
Seat Back
with Restraints
Seat Bottom
with Restraints
Note: The seat bottom has three parts:
high chair seat, youth chair seat and
chair attachment base.
Pad Tray Insert
Note: The tray insert is
attached to the tray.
Tray
Infant Insert
Front Base
Back Base
2 Frames
(Left and Right)
Footrest
with Baby Wipes Compartment

4
Back Base
1
2
3
Assembly and Setup for Full-Size High Chair
Assembly steps 1-5 are one-time or a permanent assembly.
Steps 6 - 16 complete assembly/setup for use as a full-size high chair.
•Press the latch on the frame and open the leg
until it "snaps" into place.
•Repeat this process to open the other frame.
PRESS
PRESS
PRESS
PRESS
PRESS
Frame
Frame
•Position the back base so that it curves
away from you and the latch on the frame
faces out.
•While pressing the button on the frame, fit
the end of the frame into the back base until
you hear a "click".
Hint: The frames are designed to fit the back
base one way. If a frame does not seem to fit,
try the other frame.
•Pull up on the frame to be sure it's secure to
the back base.
PR
PR
•While pressing the button on the back base,
insert it up into the remaining frame until you
hear a "click".
•Pull up on the frame to be sure it's secure to
the back base.
4
Seat Bottom
FRONT VIEW
FRONT VIEW
Se
Se
•Turn the assembly around so that the other
side of the frame is facing you.
•Fit the seat bottom onto the ends of the
frame. Slide the seat bottom all the way up.
Note: The seat bottom has three parts:
high chair seat, youth chair seat and chair
attachment base. All three parts of the seat
bottom are used for Full-Size High Chair use.

5
Assembly and Setup for Full-Size High Chair
Assembly
and
Se
5
Front Base
•Position the front base so that it curves away
from you.
•While pressing the buttons on the front base,
lower the front end of the frame assembly
into the front base until you hear a "click" on
each side.
•Pull up on the frame assembly to be sure it's
secure to the front base.
PRESS
PRESS
PRESS
PRESS
6BACK VIEW
Seat Back
•At an angle, fit the front tabs on the seat
back into the openings in the top of the seat
bottom A.
•Push the seat back to "snap" both large tabs
into place B.
•Pull up on the seat back to be sure it's secure
to the seat bottom.
A
B B
A

6
9
10
Crotch Belt
Waist Belts
Lowest Slots
•Fit the crotch belt up through the large
opening in the pad.
•Fit the waist belts through the lowest slots in
the pad.
7
PRESS
SIDE VIEW
LIFT
•Press the seat back adjustment button and lift
the seat back into the fully upright position.
Assembly and Setup for Full-Size High Chair
8FRONT VIEW
•Place the pad onto the seat.
Pad

7
Assembly and Setup for Full-Size High Chair
11
12
Shoulder Belts
Lower Slots
Shoulder Belts
Upper Slots
Smaller Baby
•Fit the shoulder belts through the lower slots
in the pad for a smaller baby.
Larger Baby
•Fit the shoulder belts through the upper slots
in the pad for a larger baby.
13
14 FRONT VIEW
HooksHooks
SIDE VIEW
•Fit the upper pad pocket over the seat back.
•Fasten the hooks on the pad to the front edge
of the seat.

8
Assembly and Setup for Full-Size High Chair
15
Infant Insert
•Fit the shoulder belts and the waist belts
through the slots in the infant insert.
16
Footrest
•At an angle, fit the tabs on the footrest into
the sockets in the front of the seat. Lower the
footrest in place.
Note: The footrest includes a baby wipes
storage compartment. See page 19 for
instructions to load baby wipes (not included,
sold separately) into the compartment.

9
4 products in 1!
Full-Size High Chair
(See pages 4-8)
Booster Seat
(See pages 12-15)
SpaceSaver High Chair
(See pages 10-11)
Youth Chair
(See page 15)
1
3
2
4

10
SpaceSaver High Chair Setup
1
Footrest
•Lift to remove the footrest.
2
•Press the upper buttons on the sides of the
seat bottom and lift to remove the high chair
seat from the youth chair seat.
3
•Press the lower buttons on the sides of the
seat bottom and remove the chair attachment
base from the youth chair seat.
Chair
Attachment
Base
4
•Position the attachment straps on the chair
attachment base, as shown.
TOP VIEW
PRESS
PRESS
PRESS
PRESS
PRESS
PRESS
PRESS
PRESS

11
5
FRONT VIEW
FRONT VIEW
•Fit the high chair seat to the chair attachment
base. Push to "snap" in place.
SpaceSaver High Chair Setup
High Chair Seat
Chair
Attachment
Base
6
•Place the seat on an adult chair.
•Wrap the bottom attachment straps around
the bottom of the adult chair A.
A
D
D
8
•Wrap the back attachment straps around the
back of the adult chair D.
•Buckle the attachment straps E. Make sure
you hear a "click."
•Pull the free end of the attachment strap to
tighten on the adult chair F.
E
F
BC
7
•Buckle the attachment straps B. Make sure
you hear a "click". Pull the free end of the
attachment strap to tighten on the adult
chair C.

12
3SIDE VIEW
•Remove the pad upper pocket from the
seat back.
2
HooksHooks
•Unfasten the hooks on the front edge of the
pad from the seat bottom.
Booster Seat Setup
1
Footrest
•Lift to remove the footrest.
4
•Push the waist and shoulder belts back
through the slots in the infant insert and
the pad.
•Remove the infant insert.

13
Booster Seat Setup
6
Pad
•Remove the pad from the seat.
7
•Lift the large tabs on the seat back and
remove the seat back.
8
•Press the upper buttons on the sides of the
seat bottom and lift to remove high chair seat
from the youth chair seat.
5FRONT VIEW
•Push the crotch belt down through the large
opening in the pad.
Crotch Belt
LIFT
PRESS
PRESS
PRESS
PRESS

14
9
Booster Seat Setup
•Press the lower buttons on the sides of the
seat bottom and remove the chair attachment
base from the youth chair seat.
Chair
Attachment
Base
10
•Position the attachment straps on the chair
attachment base, as shown.
TOP VIEW
11
FRONT VIEW
FRONT VIEW
•Fit the seat to the chair attachment base.
Push to "snap" in place.
Seat
A
12
•Place the seat on an adult chair.
•Wrap the bottom attachment straps around
the bottom of the adult chair A.
•Buckle the attachment straps B. Make sure
you hear a "click". Pull the free end of
the attachment strap to tighten on the adult
chair C.
BC
PRESS
PRESS
PRESS
PRESS

15
Booster Seat Setup
D
D
13
•Wrap the back attachment straps around the
back of the adult chair D.
•Buckle the attachment straps E. Make sure
you hear a "click."
•Pull the free end of the attachment strap to
tighten on the adult chair F.
E
F
Youth Chair Setup
1
Footrest
•Lift to remove the footrest.
2
•Press the upper buttons on the sides of the
seat bottom and lift to remove the high chair
seat from the youth chair seat.
PRESS
PRESS
PRESS
PRESS

16
A
B
Securing Your Child
•To tighten the waist belts: Feed the anchored
end of the belt up through the buckle to form
a loop A. Pull the free end of the belt B.
Repeat this procedure to tighten the other
belt.
•To loosen the waist belts: Feed the free end
of the belt up through the buckle to form
a loop A. Enlarge the loop by pulling on the
end of the loop toward the buckle. Pull the
anchored end of the belt to shorten the free
end of the belt B. Repeat this procedure to
loosen the other belt.
2
A
B
B
B
A A
3
To tighten the shoulder belts:
•Hold the adjuster Aand pull the front
shoulder strap down B.
To loosen the shoulder belts:
•Slide the adjuster down.
TIGHTEN LOOSEN
•Place your child in the seat. Position the crotch
belt between your child's legs.
•Fit the end of each waist belt through the end
of each shoulder belt.
Note: There are no shoulder belts for booster
seat use.
•Fasten the waist/shoulder belts to the crotch
belt. Make sure you hear a "click" on
both sides.
•Check to be sure the restraint system is
securely attached by pulling it away from
your child. The restraint system should
remain attached.
•Tighten each waist/shoulder belt so that the
restraint system is snug against your child.
Please refer to the next section for instructions
to tighten the waist/shoulder belts.
1
A
B
A
B

17
2
Tray Insert
•Place the tray insert onto the tray.
Tray Use
•Press the button on the front of the tray
to move the tray forward, backward or
to remove.
1 3
Tray
PRESS
PRESS
•Fit the tray onto the armrests.

18
Seat Recline Adjustment
•Press the button on the back of the seat
and lift or lower the seat back to the
desired position.
Seat Height Adjustment
•Press the latches on each side of the frame
and lift or lower the seat to the desired height.
PRESS
PRESS
PRESS
Wheel Locks
1
2
•Lower the tab on each rear wheel to lock
in place.
•Lift the tab on each rear wheel to unlock
the wheels.

19
Baby Wipes Compartment
1
2
Footrest
•Lift to remove the footrest.
•Place the footrest face down.
•Spread the clips on the footrest and remove
the baby wipes compartment.
Baby wipes are not included and sold separately.
Baby Wipes
Compartment
BOTTOM VIEW
Clips
3
•Open the door on the compartment.
4
•While pushing the spring loaded plate,
insert a container of baby wipes (not included
and sold separately).
5
•Close the door.
PUSH

20
Baby Wipes Compartment
6
•Fit the baby wipes compartment into the back
side of the footrest.
Footrest
7
•At an angle, fit the tabs on the footrest into
the sockets in the front of the seat. Lower the
footrest in place.
BACK VIEW
Storage
1
•Turn the tray face down. Pull the latches out.
•Fit the tray onto the high chair legs.
2
•When replacing the chair attachment base to
the bottom of the seat, be sure the straps are
rolled and within the compartment, as shown.
PULL
PULL
BOTTOM VIEW
BACK VIEW
Tray