FLACARP X7 User manual

Bite alarm with listening-in device
FLACARP X7 and RX7 receiver
INSTRUCTIONS FOR USE
QUALITY
EUROPEAN
PRODUCTS
Thank you for buying the FLACARP bite alarms.
These pure Czech products reect the needs of modern anglers and
combine the state-of-the-art electronics with the best materials while
keeping the practicality and high reliability. The products are completely
developed and produced here in the Czech Republic, and for this reason we
can offer excellent services and a exible reply to your requirements.
[phone] |[e-mail] |www.flacarp.com

RGB LED COLUMN
It indicates the bite and the direction
of the shing-line unwinding with
memory.
RED LED
Permanent light or ashing indicates
low battery (see more on page 5).
FC BUTTON (function)
Functions control (MUTE, night
position LED, see below).
SOUND
Acoustic indication of sh bite and
functions.
CONNECTOR
For swinger connection.
BATTERY REPLACEMENT
Unscrew the lock nut and open the
rear cover to replace the batteries.
Batteries: 2 pcs LR03 (AAA). Use
only high - quality alkaline or lithium
batteries (2x 1.5V).
SENSITIVITY REGULATION
■Highest sensitivity on the right side
(the nest shing line movement).
■Lowest sensitivity on the left side
(the longest shing line movement).
■The “S” button can also be used to
choose the LED colour – see below.
BEEP HEIGHT ADJUSTMENT
■Turn to the right to increase the
beep height.
■Turn to the left to decrease the
beep height.
■The „T“ button can also be used to
choose the LED brightness – see
below.
VOLUME CONTROL
■ Turn to the right to increase the
volume.
■Turn to the left to decrease the
volume.
MAIN SWITCH
■ON (the lever up).
■OFF (the lever down).
MAIN LOAD-BEARING SCREW
1
1
2
8
7
3
9
4
10
5
6
11
7
2 8
4
9
510
611
ON
OFF
3
1
[phone] |[e-mail] |www.flacarp.com
BITE ALARM - CONTROL ELEMENTS

X7 bite alarm- switching on / off:
■To turn on the bite alarm: Set the switch to ON position (the lever up).
■To turn off the bite alarm: Set the switch to OFF position (the lever down).
MUTE (to switch off the sound and the transmission temporarily):
To turn on the MUTE function:
■Briey press the FC function button.
■The MUTE function is indicated by the middle LED ashing.
To turn off the MUTE function:
The function is cancelled automatically after 30 seconds after the last sh-line
movement or can be switched off by pressing the FC button.
Night position LED (NIGHT):
To turn on the NIGHT function:
■Press the FC button for 2 sec.
■Activation (deactivation) of the NIGHT function is signaled by a short beep sound.
■The green position LED at the top will lights up dimly.
Termination of the NIGHT function:
Same procedure as for the switch on function. Or switch the bite alarm off (lever to the
OFF position).
RGB LED colour and brightness adjustment, full switching-off of LED (discrete mode):
To turn on the RGB function:
■ Press the FC button for 5 sec.
■After a while, the signaling LEDs start “running” up and down.
■Now, you can choose the colour by turning the “S” button.
■By turning the “T” button adjust the brightness of the LED or turn off the LED
completely.
To turn off the function for LED colour and brightness choice:
The function can be turned off by briey pressing the FC button or by switching off the
indicator (the lever down, OFF position).
Fluctuating beep at high-speed ride:
Fast unwinding of the line is signaled by a long-drawn tone. You can activate more
signicant signaling the fast unwinding of the line (the ride) by a uctuating beep:
Switching on/off the uctuating beep at the ride:
■Press the FC button 10 times in rapid succession.
■A short beep sounds, and the green LED ashes shortly.
■To switch the function off, use the same procedure.
2
[phone] |[e-mail] |www.flacarp.com
2
BITE ALARM - FUNCTION DESCRIPTION

INDICATING CHANNEL RGB LED
LED indication of particular channels
(up to 12 devices can be stored). The
LED colour is identical with the one
set-up on the bite alarm.
MULTIFUNCTIONAL LED
It displays:
BATTERY STATUS
■GREEN = battery charged.
■RED = low battery.
ALARM
■Flashes alternately in the case
of an alarm from external
sensors.
SOUND
For sound indication of a bite.
LOOP
For a neck string to be drawn through.
MULTIFUNCTIONAL PUSH
BUTTONS +/-
■Volume adjustment (PLUS and
MINUS push buttons).
■Switching-on of vibrations (hold
the PLUS push button for 1
second).
■Switching-off of vibrations (hold
the MINUS push button for 1
second).
■Enter the pairing mode (see
below).
ON/OFF button
■To switch the receiver on or off,
hold for approx. 1 second.
■Short multi-press can be
controlled remotely up to 4
FLACARP lights (see Description of
functions).
BATTERY REPLACEMENT
Slide the cover on the back receiver
side.
Batteries: 2 pcs LR03 (AAA). Use only quality alkaline or lithium batteries (2x 1.5V).
1
1 5
2
6
3
7
4
4
5
2
6
7
3
3
[phone] |[e-mail] |www.flacarp.com
RECEIVER - CONTROL ELEMENTS

Receiver switching on / off:
To switch on the receiver:
■Press the ON / OFF button for approx. 1 sec.
■A double short beep will sounds, and LEDs ash briey towards the right; LED BAT
indicates the battery charge (green LED = battery OK).
To switch off the receiver:
■Press the ON / OFF button for approx. 1 sec.
■A long-drawn deep beep will resound, and LEDs ash briey towards the left.
Pairing with the bite alarm (or other accessories):
■Press and hold the PLUS and MINUS buttons together for 1 second.
■A white LED comes on at position 1.
■Use the PLUS and MINUS buttons to move to the position where you want to save the
new device. Rotate the roller of the bite alarm, which sends a signal and the receiver to
save it. Pairing is completed.
If a deep beep sounds at pairing, and the white LED is still on (the bite alarm has not been
paired), the position is already occupied, or the same bite alarm has already been saved
in the memory. In the same way, you can also pair other accessories (alarm devices). You
have up to 12 channels available, two devices for each LED. The rst group of six lights
with white LED while learning, the other group of six lights with red LED.
Removal of bite alarm from the memory:
■Press the PLUS and MINUS side push buttons together.
■A white LED comes on at position 1.
■Use the PLUS and MINUS buttons to move to the position you want to delete (release).
■Press the MINUS push button and hold for 1 second. = deleted.
■The deletion is indicated by a quite deep beep and the red LED at a given position (1 – 6).
Differentiation of parachute at receiver:
Flashing LED = parachute indication.
Remote control of FLACARP lights:
The receiver allows you to control FLACARP lights remotely. Simply by short pressing
the main push button on the receiver, you can control up to four FLACARP lights. Press
this main push-button once, you control the rst light; when you press the push-button
twice, you control the second light; when you press the push-button three times, you
control the third light; when you press the push-button four times, you control the
fourth FLACARP light. The transmitting, or the chosen channel is displayed by short
lighting-up of LED No. 1–4 on the receiver.
Clear adjustment of sound volume:
When adjusting the volume using PLUS and MINUS side push buttons, the volume level
is now clearly displayed by a LED column on the receiver (1-6).
Range of receiver, battery life:
Our bite alarms are equipped with a high-powered transmitter for a long range. The reason
for this super-sized range consists in its excellent spreading even in the case of obstacles,
dams, and terrain irregularities, which reduce the range signicantly. Our receiver will be thus
reliable even in places where other bite alarms can fail. The battery lifetime corresponds to
the frequency of product use and to the intensity of sound indication; at bite indicator, it also
depends on the adjusted LED brightness and beep volume. The higher LED brightness or
the more intensive beep, the shorter battery lifetime. If you do not use the bite indicator for a
longer period of time (at the end of the season), we recommend to remove the batteries to
avoid product damage caused by leaking batteries.
4
[phone] |[e-mail] |www.flacarp.com
RECEIVER - DESCRIPTION OF FUNCTIONS

Clear indication of battery condition at FLACARP X7 bite alarm:
The battery status can be displayed by briey pressing the FC button when device
turned off (main switch in OFF position).
■All three colours are on (full column - green + blue + red) = battery is fully charged,
lifespan up to several months.
■Only blue + red are on = battery capacity is below 50%, lifespan still several weeks.
■Only red is on = low battery capacity, lifespan only for several days, max. weeks. It is
necessary to replace the battery.
The signalling is indicative, and it is very dependent on the type of batteries, condition
of batteries, temperature, and especially frequency of bites. However, it can avoid the
situation when the angler comes to the water, and bite alarm switches off because the
batteries are empty.
Before your trip, you only need to verify the battery condition by pressing the FC button
shortly. Moreover, the indicator also includes the energy saving function:
■If the battery capacity drops below a dangerous limit, it reduces the consumption by
decreasing the LED brightness and sound intensity to achieve a reliable assessment of
the bite.
This function can extend the battery lifespan even by 10%. If the battery capacity is very
low, the bottom LED slightly ashes in red (5times after switching on, after a bite, or
another event). If the bottom LED is permanently on, the battery capacity is critical, and
the indicator can fail to work.
100%
Full battery
50%
Battery medium
capacity
10%
Low battery
5
[phone] |[e-mail] |www.flacarp.com
FLACARP - QUALITY EUROPEAN PRODUCT

Intended use:
The FLACARP bite alarm is intended for signaling the sh bite, by evaluation line
unwinding.
Warranty:
FLACARP products are guaranteed for 24 months. The warranty does not apply for
damage caused by use contrary to these instructions, for damage caused by leaking
batteries, chemicals, high temperatures, unskilled strike, mechanical damage and
disproportionate stress contrary to the purpose use. Whether your product is under
warranty or after warranty, we will always try to help you and solve a possible problem.
EU Declara formity
of a radio device with the European Dir e RED 2014/53/EU, establishing technical requirement for radio equipment, and
the Governmental Decree No. 481/2012 Col., which is harmonized with Dir e 2011/65/EU, about the use of some
dangerous substances in electrical and electronical devices.
Manufacturer: TFE elektronika s.r.o., names vobody 1509, 696 81 Bzenec, Czech Republic
declares that the product
Sort of equipment:
Type:
Frequency:
Tr er:
Modula
Purpose of use:
It complies with the requirements of following standards and regula elevant for the specified sort of equipment:
Radio parameters:
EMC:
Safety:
RoHS:
ETSI 300-220-1 v.3.1.1
ETSI 300-220-2 v.3.1.1
ČSN ETSI EN 301 489-1 v.1.9.2
ČSN EN 55032
ČSN EN 55024
ČSN EN 62368-1
ČSN EN 50581
and it is safe, if used under c ommon applica ordance with opera
FLACARP fisherman signaling device set
FLACARP X7, FLACARP RX7, FLACARP FL5, FLACARP AL1, AL2
868,32 MHz
max. 14dBm
GFSK
signaling of fish engagement with wireless signal transmission
Bzenec,
1.3.2022 Tomas Flajzar , company director
The Declara esponsibility of the producer.
FLACARP - EU DECLARATION OF CONFORMITY 6
[phone] |[e-mail] |www.flacarp.com

PRODUCER, SERVICE, TECHNICAL SUPPORT:
TFE elektronika s.r.o., náměstí Svobody 1509, 696 81 Bzenec, Czech Republic
Tel.: [phone], email: [e-mail], eshop: www.acarp.com
X7EN1
We produce a lot of accessories for FLACARP signaling devices:
For example, waterproof outdoor-bivouac light FLACARP FL6-RGB with powerful
rechargeable battery. You can easily charge from a regular phone charger, from car or
power-bank. We also offer motion detectors FLACARP AL2 that you warns of the entry
of an unwelcome person into the guarded area. And the NEW is small FLACARP SENS
micro-alarm, which detects shocks and changes of position, which will help you guard
your equipments. Alarms and detectors alert you to the unwelcome person by sending
a signal to your receiver.
You can nd details and other accessories at www.acarp.com
Handy micro-alarm
FLACARP SENS
A small smart box will help guard your equipments.
Waterproof RGB light with listening-in reciever
FLACARP FL6-RGB
Waterproof rechargeable LED light with listening-in,
long range and LED colour adjustment options.
Can be used in the bivouac and outdoors.
Motion sensor
FLACARP AL2
The motion detector alerts to
the unwanted person.
7
[phone] |[e-mail] |www.flacarp.com
FLACARP - FOR YOU