Fleximounts WB107B User manual

96" x 48"

1. To build a 3'x6' workbench, we recommend using:
Length
72"
72"
72"
69"
36"
74.5"
H
Qty (pcs)
3
1
1
6
6
1
4
Width
36"
8.9"
13.8"
3.5"
3.5"
3.5"
2.3"
Thickness
0.8"-1.2"
0.8"-1.2"
0.8"-1.2"
1.5"
1.5"
1.5"
1.5"
Board (a)
Board (e)
Board (f)
Lumber (b)
Lumber (c)
Lumber (d)
Lumber (g)
2. To build a 2'x4' workbench, we recommend using:
Length
48"
48"
48"
45"
24"
47.7"
H
Width
24"
8.9"
13.8"
3.5"
3.5"
3.5"
2.3"
Thickness
0.8"-1.2"
0.8"-1.2"
0.8"-1.2"
1.5"
1.5"
1.5"
1.5"
Board (a)
Board (e)
Board (f)
Lumber (b)
Lumber (c)
Lumber (d)
Lumber (g)
Qty (pcs)
3
1
1
6
6
1
4
PL EA SE N O T E:
This sheet only provides recommendations for the most popular workbench dimensions.
Additional size configurations are available if desired.
AB
St4.2 x 19
Tapping Screw
x 76
St5 x 70
Tapping Screw
x 18

A
A
A
Use cordless power drill to fix lumber (c) x 6 to the installed table leg x 4 with screw (a) x 24.
2 table leg sets in total.
Use cordless power drill to fix lumber (b) x 6 to the installed table leg set x 1with screw
(a) x 12.
Place board (a) x 2 on the middle and lower beam of the table. Use cordless power drill
to fix table legs with screw (a) x 12.

A
A
A
A
D
Bx18
Note: The number of screws can be
reduced according to the size of the
workbench.
Place lumber (d) on the triangle fixed plates ③, and place board (a) on the top of table
to complete the installation of workbench.
Then, fix the top, middle and lower layers of boards and lumbers with screw (b) (the
position of the screws should be at the equal-division points).
Insert shelf holder ④ to lumber (g) as direction shown below.
Use cordless power drill to fix them with screw (a) x 12.
4 sets in total.
Place board (e) and board (f) on the shelf holder set as shown below.
Use cordless power drill to fix them with screw (a) x 8.
Place shelf on workbench as shown below.
Use cordless power drill to fix them with screw (a) x 8.
Note: The position of middle shelf
holder can be adjusted according to
demand, but the two sets must be
horizontal.