Flexsteel home Nirvana 165062PH User manual

Flexsteel Power Recliner with Power Headrest
Part List
Read these instructions carefully, and familiarize yourself with each procedure before assembling the furniture. Check that you
have all the component parts, and familiarize yourself with each part before proceeding.
Take all the fittings out of the plastic bag and separate them into groups. Ensure you have enough space to lay out all the parts
before assembly. To prevent damage to the parts, we recommend that you assemble the unit on a soft, level surface.
IMPORTANT NOTE
3
B1
left side
B2 Center B3 R
ight side

Assembly Instructions
STEP 1
Detach the wall plug transformer from the bottom of Seat (A). (See Figure 1.) and set it aside to be used in STEP 4.
Figure 1
STEP 3
Flip up the back flaps, and remove the headrest cables at the middle bottom from the Backs (B). Plug the Headrest
connecters (if applicable). (See the Figure 3.)
STEP 2
Attach the Back (B) to the Seat (A). Ensure the latches fit well. (See Figure 2.)
Figure 2
Figure 3
STEP 4

Care and Maintenance
STEP 4
Attach the power transformer cord found in STEP 1 to the matching Plug found at the bottom rear of The dual power
recliner as seen below . Make sure to close the clip lock to prevent the connection from coming loose. See the Figure 4.)
STEP 5
Fasten the back flap to the bottom of the furniture. (See Figure 5.)
STEP 6
Plug the transformer into a nearby outlet, still making sure it is clear of the metal base
.
· To avoid any risk of suffocation to children or pets, dispose of all plastic bags immediately.
· To ensure proper performance, occasionally check for loose screws and tighten as needed.
· If the reclining functions are not working properly, check for loose cable connections before
Figure 4
Figure 5