FlightScope Mevo+ User manual

Mevo+ User Manual
Performance data you can trust

“FlightScope technology is developed to offer you performance data you
can trust in your pursuit of excellence.”
Performance data you can trust
Henri Johnson - Founder & CEO

Contents
Battery Warning
Performance tracking
In the box
Mevo+
Battery isolation tab
Charging
Battery and charging indicators
System indicators
Get the app
Connect to Mevo+
Using QR Code
via Wi-Fi
Kickstand
1
2
3
4
5
6
8
9
10
10
12
13
14
15
15
16
17
18
21
22
23
24
27
28
29
31
Setup
Setback
Aiming
Clearance
Tips
Indoor ball spin
Aluminum sticker alignment
Switch off
Electronic noise
Care
Avoid
FAQ’s and support
Technical specifications

Battery Warning
CAUTION: This device contains a Li-ion battery. Do not expose to temperatures below freezing
point. Do not expose to excessive heat. Avoid physical impact, puncture, crushing or dropping.
If the unit is struck by a club or ball, a short circuit or other heat reaction may occur, resulting in a fire.
Do not tamper with the battery pack. Avoid physical damage or stress when removing or inserting
the battery. Do not short-circuit the battery terminals. Maintain battery condition by charging and
discharging regularly, at least every few months.
Use only the included charger and charging cable for best results. If the battery bulges, emits fumes,
or becomes very hot, disconnect it from the charger and replace the battery. Dispose of old batteries
in accordance with applicable waste battery and recycling regulations.
1

Visit MyFlightScope.com to analyze and track your data performance over time.
Join the MyFlightScope.com community and connect with fellow golfers FlightScope users.
Keep track of your stats over time, spot trends or tendencies and monitor how you have improved.
Performance tracking
myFlightScope.com
Please share your results and tag us on social media.
@flightscopegolf 2

Mevo+
Power adapter
Case
Simulator angle
Quickstart guide
USB charging cable
12
3 5
4
67
Aluminum stickers
In the box
(Only needed for indoor use)
(Not to scale)
3

Mevo+
6
1
2
3
4
5
Indicator lights
USB charging port
On/Off button
Kickstand
Battery and USB port (under rubber band)
Camera
2
3
1
4
5
6
4

PULL
Battery isolation tab
If the rubber band is misaligned
after the tab has been removed,
gently press rubber into the groove.
Before using, the battery isolation tab must be removed completely.
Pull firmly to remove.
5

3500mAh
100%
enough for
1½
hr
session
Power and charging
3-4hrs for a full charge using
the supplied adapter.
If the unit is unable to charge please contact
support at support@flightscopemevo.com
6

above 75%
above 50%
above 25%
above 10%
under 10%
Battery and charging indicators
0-25%
25-50%
50-75%
75-100%
Full
ChargingBattery Powered
Charging error
(Battery too hot or cold to charge,
or battery is not connected properly)
7

0-25%
25-50%
50-75%
75-100%
Externally Powered
(Battery not charging)
(Battery too hot or cold to charge,
or battery is not connected properly)
0-25%
25-50%
50-75%
75-100%
External & battery power
(External power is not sufficient to power system)
8

Battery empty
Connection Status
Radar Status
Triggered
Power on, switching on
Processor start up 30-60 seconds
Sleep
Standby mode
Armed, ready to measure
Processor shut down 15-30 seconds
Firmware error
System indicators
Ready
Connected
Communication Error
9

Get the app
Scan the QR code on
the bottom of the box
The app download will
begin automatically.
If not, you will be directed to
a simple selection process.
Download and install the FS Golf app.
10

Switch on
Wi-Fi on Launch FS Golf app
The username and password you setup
will be the same for myflightscope.com
Connect to Mevo+ (using QR code)
1 2 3
Press and hold until
the unit beeps
123
11

4 5
In app, scan QR code
on back of unit
Connected
45
12

Connect manually (via Wi-Fi)
5
4
3
2
1Make sure your phone’s Wi-Fi is turned on.
Press the on/off button on the unit, the system and battery lights will come on.
The connection light will be solid blue while the unit is ready for connection.
Select Wi-Fi settings on your phone and select the unit with your serial number.
The Wi-Fi password is your serial number, for example: M2-123456.
The connection light on the the unit will turn to solid green when connection has
been established.
Launch the app on your phone and proceed.
If you are unable to connect using the QR code, then you can connect
manually in your device settings. Follow these easy steps:
1
1
2
2
3
3
4
4
5
5
13

Do not over extend the kickstand
or force it past it’s open position,
this can cause damage to your unit.
Kickstand
Using the simulator angle, adjust the kickstand to the correct tilt of 12°.
Between 11° and 13° is within reasonable tolerance.
Open the kickstand and adjust the tilt using the simulator angle.
14

Setup - Setback
OUTDOOR
Unrestricted
ball flight
INDOOR
13’ (4m) min.
SHORT INDOOR
8’ (2.4m) min.
Aluminum stickers required Aluminum stickers requiredAluminum stickers NOT required
7’-8’ (2.1m-2.4m)
sensor to tee
8’ (2.4m)
sensor to tee
8’ (2.4m)
sensor to tee
15

Aiming
Place the Mevo+ behind the ball position so that the
camera aims along the chosen target line.
In the App, follow the instructions
using the camera view to align.
Adjust the position and aim so that the vertical
line on the camera view passes through the
ball and is aligned with the target.
12
1
12
2
16

Clearance
KEEP CLEAR
Keep area between Mevo+ and the ball position clear of any objects and people.
17