O'jump 680 User manual

18/01/2021
1
N°291
(UK) Assembly Instructions
Adjustable rom ground
balance beam
Re . : 680

18/01/2021
2
Thank you or buying this product O'jump. We advise you to read the assembly instructions
care ully. The apparatus is presented in pre-assembled parts or a simpli ied assembly. We
have designed this O'jump product to bring you complete satis action. I you need help, the
O'jump team is at your disposal to accompany you.
Warning:
This equipment must only be used by one person at a time and under the supervision o a
quali ied individual, with appropriate landing mats.
Using this equipment or purposes other than those originally intended is prohibited.
Recommendations:
- keep these instructions or subsequent re erence (inspection, maintenance, etc.).
- periodically carry out predictive maintenance.
- depending on how much it is used, have the equipment serviced yearly or every ew years.
Footprint and weight:
- Apparatus 500x100 cm
- 101Kg

18/01/2021
3
Tools needed to assemble the apparatus .
Hardware listing (pre-assembled)
Hex wrench N°18/19
Allen
wrench N°10, 8, 5
X4
M12 x 120
A
Ø24x13
B
X8
X4
M12
C
End cap M12
X4
D
C rcl ps
X2
E
M10 x 45
X2
F
M5 x 16
X4
G
Index ng knob
X2
H
I
X2
Inner clamp ng
plate
J
X2
Beam end caps

18/01/2021
4
Legs
X2
List o parts (pre-assembled)
X1
Feet
X2
1
Feet
+
1
Leg
(
2
p
ackage
s
)
1
Beam body
(1
p
ackage
)

18/01/2021
5
Assembling Legs
1) Remove the end caps.
1)
J
2) Place the beam body upside down on the loor and put in place the leg.

18/01/2021
6
Unscrew and pull the indexing knob while sliding
the leg.
3) Inserting the indexing knob into the beam body
Put in place the knob in ront the F Position then release to insert the
indexing pin.
Allen
wrench
N°8

18/01/2021
7
4
4) Inserting o the inner clamping plate in
the beam body
Until the irst hole.
Allen
wrench
N°8
1
2
3

18/01/2021
8
Assembling eet.
H
ex wrench
N°
18
/19
Allen
wrench N°10

18/01/2021
9
Turn the beam over and then replace the beam end caps.

18/01/2021
10
Height adjustment
Unscrew
and pull
the knob
to release
the indexing pin.
Slide the oot sideways. Release the
knob in ront o the desired position.
Lock the knob by tightening.
Repeat or the other oot.
Warning:
Sa ety is always the main consideration when setting up an apparatus.
• It is important to always have a good understanding o the task.
• Use common sense.
. Always hold the beam with one hand when unscrewing the knobs
. Risk o injury in the event o a sudden all o the beam body.
Height adjustable rom 50 to 125 cm in steps o 5 cm
.