Focal IFRA165-4.1 User manual

FOCAL/RENAULT
INSTALLATION OF LIVE/PREMIUM KITS FOR
Clio 5 –January 2019

2
RECOMMENDATIONS BEFORE INSTALLATION
Reset all car radio audio settings:
oAmbience = Natural
oBass / Midrange / Treble settings = 0
oLoudness = OFF
oFader and Balance = Centered
The speaker drivers require a break-in period (approximately 20 hours) before
they reach optimal sound quality. Start with tracks without too much low
frequencies at a low volume. Then turn the sound up little by little.After this
break-in period, you can fine-tune the audio settings as you please.

3
I –UNBOXING AND LOCATION OF PARTS

4
I –UNBOXING AND LOCATION OF PARTS

5
I –UNBOXING AND LOCATION OF PARTS

6
I- UNBOXING AND LOCATION OF PARTS

7
I –UNBOXING AND LOCATION OF PARTS

8
II –ASSEMBLING THE FRONT SPEAKER DRIVERS
1. Equipment required for assembling the woofer

9
II –ASSEMBLING THE FRONT SPEAKER DRIVERS
2. Connections
a. Insert the cable into the notch b. Before you screw, make
sure that the two logos are
aligned
c. Screw the 4 screws D. Block the crossover

10
III –ASSEMBLING THE FRONT SPEAKER DRIVERS
1. Unclip the frontdoor panel
a. Unclip and unscrew then remove the frontdoor panel
1
2
3
4

11
III –ASSEMBLING THE FRONT SPEAKER DRIVERS
2. Remove the original speaker driver
a. Pierce the 3 rivets’ head.
Note : Keep the spacer riveted
to the door frame.

12
III –ASSEMBLING THE FRONT SPEAKER DRIVERS
3. Installing the front speaker drivers
a. Rivet on the door frame and connect the Focal speaker driver.
Note : Some version may use screws. If so,do not
use the rivet

13
IV –ASSEMBLING THE TWEETER
1. Equipment required for assembling
the tweeter
2. Remove the tweeter’s grille by
simply unclipping it

14
IV –ASSEMBLING THE TWEETER
3. Slot the tweeter into the spacer
Note : The two parts must
be displayed as shown
above.
4. Connect at position 2
Note : Position 1 is not
used for this vehicle

15
V –CONNECTING THE TWEETER
1 Remove the tweeter grille
2 Remove the tweeter
Note:
Do not
forget to
put the
screw
back

16
V –CONNECTING THE TWEETER
3 Connect the crossover

17
VI –ASSEMBLING THE REAR SPEAKER DRIVERS
1. Unscrew 2. Remove the door panel
1 2
3
4

18
VI –ASSEMBLING THE REAR SPEAKER DRIVERS
3. Remove the original speaker driver
a. Pierce the 3 rivets’ head

19
VI –ASSEMBLING THE REAR SPEAKER DRIVERS
4 Installing the rear speaker driver
a. Rivet on the door frame and connect the Focal speaker driver.
Note : Orientate the tweeter
by turning it up or down

20
VII –PREPARING THE SUBWOOFER
Ground cable Power cable Heat shrinkable
sleeve Power connector Subwoofer cable with
remote control Adapter
Ibus 2.1 Extension cable Head unit –subwoofer
interconnect cable Connectors
Hook-and-loop fasteners
(e.g. Velcro®)
1. Equipment required for installing the subwoofer