Forever Redwood Cocktail Bar Stools User manual

Redwood Cocktail Bar Stools with Swivel www.foreverredwood.com
866.332.2403 (Toll Free); 7am-7pm Pacific Time, Monday-Saturday
Assembly instructions for:
REDWOOD COCKTAIL BAR STOOLS
WITH SWIVEL

Redwood Cocktail Bar Stools with Swivel www.foreverredwood.com
CONTENT OF BOXES
Quantity
Description
Drawing
18
Carriage bolts 3 ½”x 5/16”, Washers & Nuts
2
Carriage bolts 4 ½”x 5/16”, Washers & Nuts
1
Seat with swivel base
1
Backrest
2
Arm assemblies left & right
2
Leg assemblies left & right
1
Leg support
2
Supports

Redwood Cocktail Bar Stools with Swivel www.foreverredwood.com
ASSEMBLY INSTRUCTIONS
Thank you for purchasing Forever Redwood patio furniture. Forever Redwood is built by Old-Growth
Again Restoration Forestry (OGA).OGA is dedicated to restoration forestry. Sales of patio furniture
finance our restoration work in California redwood forestlands.
Tools required: ½-inch ratchet, a square head screwdriver and a mallet or small hammer.
Your furniture was fully assembled in the shop prior to being disassembled for shipping. All the parts fit.
The parts that go together have the same numbers written next to the predrilled holes they attach to.
Please take the time to align the parts with the numbers.
STEP 1: Attach the arm assembly left to seat, with two bolts (3 ½” x 5/16”), washers & nuts (Match up
the numbers to attach the two parts together). Tap the bolt all the way into the wood to set it. Then add a
washer and nut and lightly tighten. Repeat this step with the other side.
STEP 2: Attach the backrest to arm assembly left, with two bolts (3 ½” x 5/16”), washers & nuts
(Match up the numbers to attach the two parts together). Tap the bolt all the way into the wood to set it.
Then add a washer and nut and lightly tighten. Repeat this step with the other side.

Redwood Cocktail Bar Stools with Swivel www.foreverredwood.com
STEP 3: Attach the seat to the leg assembly left, with two bolts (3 ½” x 5/16”), washers & nuts (Match
up the numbers to attach the two parts together). Tap the bolt all the way into the wood to set it. Then
add a washer and nut and lightly tighten. Repeat this step with the other side.
STEP 4: Attach the leg support to the leg assembly left with two bolts (3 ½” x 5/16”), washers & nuts
(Match up the numbers to attach the two parts together). Tap the bolt all the way into the wood to set it.
Then add a washer and nut and lightly tighten. Repeat this step with the other side.
STEP 5: Attach the support to the leg assembly left and seat, with two bolts, washers & nuts (Match
up the numbers to attach the two parts together). Tap the bolt all the way into the wood to set it. Then
add a washer and nut and lightly tighten. Repeat this step with the other side.
Thank you! If you have any questions, please call or email us.