Fox DSR-6000 User manual

DSR-6000
Below is the required hookup and configuration for service.
RF Hookup
Port 1: Galaxy 15 Horizontal (Odd)
Port 2: Galaxy 15 Vertical (Even)
Port 3: Galaxy 17 Horizontal (Odd)
Port 4: Galaxy 17 Vertical (Even)
CALL 1-800-334-1744 FOR
AUTHORIZATION
HD Hookup
ASI Out 1
PID’s
7680: Video
4128:AC-3 Stereo (ENG)
4129:AC-3 Stereo (SAP)
4288: DPI
SD Hookup
Video
Video Out
Audio
Audio 1 L,R: Stereo
Audio 2 L: SAP
(Selected Programming)
Ad Insertion
Relay #1
DTMF for select Networks
G17 H
(Odd) G17 V
(Even)
G15 V
(Even)
G15 H
(Odd)
ASI Out 1
Stereo L Stereo R SAP Relay 1 Ad Insertion
DTMF Ad Insertion

DSR-6000 Set up instructions.
•Tuning Satellite Feed
–From the DSR6000 Main Menu use the ◄►to select Install, press ENTER.
–Use the ▼▲ buttons to select the MANUAL TUNE menu.
–From MANUAL TUNE menu, verify Input = Port 1 and Mode =Xpndr
–Use the ◄► buttons to select Xpndr, press ENTER. Use the ▲▼ buttons to change the transponder to 21, press ENTER to save.
–From the MANUAL TUNE menu verify the L-Freq =1030.00 MHz
–Use the ◄► buttons to move the cursor to MANUAL TUNE.
–Use the ▼button to find the MODULATION menu.
–Use the ◄► buttons to select Mode, press ENTER. Use the ▲▼ buttons to select DVBS2, press ENTER.
–Press ◄► to move the cursor to the left of MODULATION.
–Press ENTER to display the DSR6000 Main Menu.
–Look for the SIGNAL LED to illuminate on the front panel. Wait no more than 30 seconds.
•Retrieving Unit Address
–From DSR6000 Main Menu use the ◄► to select Diag. Press ENTER, then use ▼button to view the Unit Address.
–Contact Fox Network Center for authorization at 1-800-334-1744.
*Go to http://foxcable.com and click on the DSR6000 install technical information