FR 100 is a dual-mode, stacked overdrive.
DRIVE mode: When the pedal is powered up, it comes on in DRIVE mode. The
signal is passed through a clear-voiced soft clipping section. This circuit is
similar to the VT and CS cards used in the Foxrox ZIM pedal.
LEAD mode: Pressing the LEAD foot switch turns the Red LED on and inserts
an additional overdrive stage before the main DRIVE section. This overdrive
adds more gain, sustain and midrange. The two stages work together to create a
clear, fluid lead tone. Press again to deactivate LEAD mode.
LEAD mode gives you both a gain boost and volume increase. The volume
increase while engaging LEAD mode can be adjustable internally. Both DRIVE
and LEAD modes are responsive to your guitar's volume knob and the dynamics
in your playing.
Tone knob and Voice switch let you match FR 100 to different amplifiers and
playing situations.
The LEAD overdrive section is identical to the H9 Overdrive card used in the
Foxrox ZIM pedal.
FEATURES
VOLUME: Controls the overall volume of the pedal. Typical setting around 1:00.
DRIVE: Controls the amount of gain in the main drive section. Typical setting
around 2:00.
LEAD KNOB: Controls the amount of gain added when the pedal is in Lead mode.
Typical setting around 2:00.
TONE: Turn down for bass, up for treble.
VOICE SWITCH: Three selections for matching FR 100 to various amps and
playing situations:
HIGH: Tightens the low end and adds resonance in the mids. Good for helping
a guitar cut through the mix on a crowded stage. Useful with amps that have a
lot of low end.
MID:This is the natural tone of the overdrive without additional tone shaping.
LOW: Fattens the low end for a warm tone. Useful with small amps and to
avoid harshness with bright amps.
WARRANTY: Foxrox warranties this pedal for 5 years against failure. Parts and labor
are covered. Warranty does not cover damage due to improper voltage, extreme abuse,
FOR MORE FR 100 INFORMATION, VISIT WWW.FOXROXelectronics.COM
