Franke Kubus KUB-PD-304 User manual

Kubus
EN Installation manual Kitchen Faucet
ES Manual de instalación Grifo de cocina
FR Manuel d‘installation Robinet de cuisine
KUB-PD-304 KUB-PR-304 KUB-BR-304

3
EN
Table of contents
Overview 4
Contents in box 4
Technical data 5
Installation instructions 5
Cleaning and maintenance 7
Replacing the cartridge 7
General maintenance 7
Spare/replacement list KUB-PD-304 / KUB-PR-304 8
Spare/replacement list KUB-BR-304 9

4
EN
Overview
Contents in box
KUB-PD-304 / KUB-PR-304
KUB-BR-304
Note: Contact us immediately if you see inconsistencies.
phone: [phone]
website: www.franke.us/ks
email: [e-mail]
KUB-BR-304
11. Faucet Assembly
12. Rubber O-ring
13. Rubber Washer
14. Plastic Flange
15. Fixing Plate
16. Fixing Nut
17. Hex Key
18. Supply Hoses
5
2
8
9
10
7
6
3
4
13
12
16
18
17
15
14
KUB-PD-304/PR-304
1. Faucet Assembly
2. Aerator Key
3. Hex Key
4. Rubber O-ring
5. Rubber Washer
6. Plastic Flange
7. Fixing Plate
8. Fixing Nut
9. Weight
10. Supply Hoses
1
11

5
EN
Technical data
Operating data Value
Operating pressure (ideal) 60 PSI 4 bar 400 kPa
Operating pressure (max.)* 115 PSI 8 bar 800 kPa
Operating pressure (min.)* 30 PSI 2 bar 200 kPa
Water temperature (ideal) 140°F 60°C
Water temperature (max.) 158°F 70°C
Hole Size For Faucet 1 3/8“ 35 mm
Installation instructions
1. Remove all contents from the package
and check for completeness.
2. Turn o water supply.
3. Cut a mounting hole 1 3/8“ diameter
(35 mm) in the desired mounting
surface (if one isn’t available).
4. Ensure Rubber O-Ring (2) is in place in
the Faucet Base (1) (g. 2A).
2A
1
2
5. Insert the faucet into the hole, hoses
rst (g. 2B).
Attention: Rubber O-Ring (2) should
be sitting between the countertop and
faucet base.
Do not use putty or other sealant at this
location.
Notes: Solid surface installation: The
countertop mounting surface needs to
be at and free of debris; otherwise the
faucet may not sit properly and could
leak.
6. Install the mounting hardware to the
mounting shank of the Faucet Base (1)
underneath the mounting surface in
the following order: Rubber Washer (3),
Plastic Flange (4) and Fixing Plate (5)
(g. 2B).
2B
3
4
5
6
7 Nm
2
Certies this faucet complies with ASME A112.18.1 / CSA B125.1, NSF/ANSI/CAN 61-2020
(AB100 compliant, Q<1 ) & NSF 372. The faucet also complies with water usage
requirements of the California Energy Commission and the US Department of Energy.

6
EN
7. Secure the faucet by tightening the
Fixing Nut (6) onto the mounting shank
of the Faucet Base (1) and tightening
the screws in Fixing Nut (6) (g. 2B).
Attention: For KUB-BR-304 - skip to
Step10.
8. Connect Spray Hose (10) to Spray
Supply Hose (11) (g. 2C).
2C
10
11
9. Attach the Weight (7) to the Spray Hose
(10) approximately 2” (50 mm) above
the bend in the bottom of the Spray
Hose (g. 2D).
2D
10
7
2”
10. Connect the Flexible Supply Hoses (12)
to the water supply in the home (g. 2E).
2E
12 12
11. For KUB-PD-304 and KUB-PR-304,
remove Aerator (13) using the Aerator
Key (9) (g. 2F).
For KUB-BR-304, remove Aerator (13)
by unscrewing the Aerator Cap (14) by
hand (g. 2G).
2G 13
14
2F
13
9
12. Turn on water, ush the faucet and
Aerator (13) to remove any debris and
check for leaks (g. 2H).
2H
13. Reinstall the Aerator (13) and ensure
everything is functioning properly.

7
EN
2.5 mm
30mm
106 in-lbs
B
C
D
A
Cleaning and maintenance
Replacing the cartridge
1. Shut o the water supply to the faucet.
2. Turn on the faucet briey to relieve any
pressure inside the Faucet.
3. Move the Faucet Handle to the “OFF”
position.
4. Remove the set screw from the Handle
Assembly (A) using a 2.5 mm Hex Key.
5. Pull the Lever Handle (A) from Faucet
Body.
6. Unscrew the Cartridge Cap (B) from
Faucet Body.
7. Unscrew the Cartridge Lock Nut (C).
8. Lift Ceramic Disc Cartridge (D) from
the body and replace it with a new one.
Ensure the two lugs on bottom of the
cartridge sit properly in the allocated
holes at the base of the body.
9. Re-assemble faucet in reverse order.
10. Test for leakage.
General maintenance
Clean aerator periodically for any buildup.
Do not use harsh detergents, solvents,
chemical agents, especially CHLORINE,
or metallic sponges as these can damage
the surface nish. Clean only with a soft
sponge and soapy water.
Do not store chemicals or cleaning
agents in the immediate vicinity of the
faucet and connection hoses. Chemical
vapors could cause damage.

8
EN
Spare/replacement list KUB-PD-304 / KUB-PR-304
1F4201 Spray Head Assembly
2F206502 Cartridge
3F3412 Cartridge Nut
4F3413 Cartridge Cap
5F4202 Handle Assembly
6F4203 Fastening Set
7F3510 Spray Supply Hose
8F4204 Hot Supply Hose
9F4205 Cold Supply Hose
10 F4206 Pull Out Spray Hose
11 F4207 Check Valve Holder Assembly
12 F205514 Weight
13 F3306 Aerator Key
14 F3305 Aerator
12
11
1
13
14
2
3
4
5
6
7
8
9
10

9
EN
Spare/replacement list KUB-BR-304
1F3410 Aerator and O-Ring
2F206502 Cartridge
3F3412 Cartridge Nut
4F3413 Cartridge Cap
5F4202 Handle Assembly
6F4203 Fastening Set
7F4204 Hot Supply Hose
8F4205 Cold Supply Hose
1
2
3
5
68
7
4

10
EN
For any further information about our products, about the installation of them or about
the warranty please contact our customer service department:
Franke Home Solutions
North America, LLC
800 Aviation Parkway
Smyrna, TN 37167, USA
Phone: [phone]
[e-mail]
F ranke Kindred Canada Ltd.
1000 Franke Kindred Way
Midland, ON LR4 4K9
Phone: [phone]
[e-mail]
Warranty website: https://www.franke.com/us/en/hs/support/warranty.html