3
Figure 5: Paper Loaded Correctly
5. Close the printer door. Leave a small amount of
paper protruding when the door is closed.
6. Restore power to the tank gauge.
Printer Retrot
Follow these instructions when installing a printer into a
TS-550evo that does not have an existing printer.
1. Remove the front cover by unscrewing the (4)
screws as shown in Figure 1. Save the screws.
2. On the plastic front cover, remove the printer blank
by prying off the two bottom clips and the top
spring clip (Figure 6)
3. Press out the printer blank insert.
Figure 6: Remove Clips
Figure 7: Remove Inserts
4. Use the at side of a screwdriver and push out the
3 plastic inserts on the inside metal cover.
5. Carefully insert the ribbon cable (Figure 3) into the
connector on the Interface board.
6. Place the new printer in position and secure it with
the 3 screws shown in gure 2.
7. On interface board located below the LCD display,
remove the jumper from (J9) (Figure 8).
Figure 8, J9 Jumper location.
8. Follow steps 3 through 6 under Installing the New
Printer.
Printer Operation Notes
• On rare occasions, when printing excessively long
reports at high ambient temperature, the printer may
need to pause momentarily. Printing will resume
automatically after a few seconds.
• An open printer door or no-paper will generate a Check
Printer alarm.
• If the console is printing but the text is not visible, check
paper roll orientation per Figure 4.
• The paper tear-bar is located at the top. Tear the paper
with a lifting motion (Figure 9).
Figure 9: Tear Paper with a Lifting Motion
Paper Specications
Type: Thermal Printer Paper
Width: 58 mm (2.28")
FFS part #: TS-TP2 (box of 5 rolls)
TS-TP2C (Carton of 20 boxes = 100 rolls)
