Freezimer IM1102-UL User manual

Follow Freezimer
Visit us: www.freezimer.com
IM1102-UL

US:[e-mail]

This symbol indicates the refrigerant R600a and the non-metal- lic materials of
the appliance are flammable. ltys a warning symbol.Warning:Risk of fire/flam-
mable materials.
WARNING: When positioning the appliance,ensure the supply cord is not trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the
rear of the appliance Children aged from 3 to 8 years are allowed to load and unload refriger-
at- ingappliances.To avoid contamination of foodplease respect the follow- inginstructions.
fl Opening the door for long periods can cause a significant increase of the temperature in the
compartments of the appliance.
fl Clean regular surfaces that can come in contact with food and accessible drainage systems.
fl Clean water tanks if they have not been used for 48 h,flush the water system connected to a
water supply if water has not been drawn for 5 days. fl lf the refrigerating appliance is left
empty for long periods,switch off, defrost, clean,dry,and leave the door open to prevent mould
developing within the appliance. Regardingthe information pertainingto the use of the
appliance,thanks to refer to the below paragraph of the manual.

SAVE THESE INSTRUCTIONS HOUSEHOLD USE ONLY
KNOW YOUR ICE MAKER
Top cover
Viewing window
Front lid
Power cord
Front housing
Top cover
Ice tray
Ice basket
Power cord
Ice basket Ice spoon
Back housing
Drain tobe

Start or stop the appliance.
“Clean” key.
The “Ice-making” indicator will light solidly
when the appliance is making ice.
The “Clean” indicator will light solidly
when the appliance is performing cleaning.
The “Ice full” indicator will light solidly
when the ice basket is full.
Defrosting indication.
The appliance is defrosting.
Water refill indication. The “Ice-making” indicator will light solidly
and the “No water” indicator will flash when the appliance needs
to be refilled. The appliance will be refilled with water automati-
cally if it is of water-refill function.

1. Ensure that the drain plug at the back of ice maker is closed well.
3. Open the front lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
5. Replace the ice basket and close the front lid.
6. Press the “ON/OFF” key and the “ ” indicator lights solidly.
7. The ice-making cycle will last approximately 15-20 minutes, depending on the
ambient temperature and water temperature.
8. The ice-making assembly is equipped inside of appliance, and the ice-making
assembly will keep producing ice when the water is pumped into it. When the
ice forms in the ice-making assembly, the ice cubes will be transferred into the
ice tray and then the ice cubes will drop into the ice basket. And the above
action will be repeated until the ice basket is full.
9. The “ ” indicator will light up when the ice basket is full and then the ice
maker will stop the ice-making cycle automatically. Open the front lid and gently
remove the ice from the ice basket with the ice scoop. And then replace the ice
basket and close the front lid, then the ice maker will restart its ice-making
function automatically. If the ice is not removed, after about 8 hours,
the appliance will automatically work again, alternatively, you can press
“ON/OFF” key to restart the appliance.
2. Plug the ice maker into the wall outlet, the “ ” indicator flashes.
NOTE: Please make the ice maker rest for 30 minutes before plug if it has
been moved.
NOTE: Do not fill above the MAX water level mark.

10. The “ ” indicator will flash when the water reservoir is lack of water.
(1) If the appliance is connected with external water source by the 1/4PE tube
shown in the section of “CLEANING AND MAINTENANCE” (see Fig.1), the water
reservoir will be refilled with water automatically and the appliance will restart
the ice-making cycle; alternatively, the user can remove the ice basket and
refill the water reservoir with water to “MAX” mark manually, and then the
appliance will restart the ice-making cycle automatically. Please remember
to close the front lid after refilling water manually avoid overflow.
(2)If the appliance is not connected with external water source, firstly remove
the ice basket and then fill the water reservoir with water manually.
After the water reservoir is refilled with water, please close the front lid, then
the appliance will restart the ice-making cycle automatically.
11. When you have got your desired amount of ice, stop the ice-making cycle
by pressing the “ON/OFF” key and unplug the unit from the wall outlet.
12.Open the front lid and transfer the ice to a freezer.
13.Allow the ice maker to reach room temperature.
14.Suggest replacing the water every a week. Please empty the water reservoir
if the ice maker is not used for a long time.
15.The ice maker can be connected with external water source by the 1/4PE tube
shown in the section of “CLEANING AND MAINTENANCE” (see Fig.1)
if you want to add the function of refilling water automatically.

To keep your ice tasting fresh and your ice maker looking great, we recommend
cleaning your ice maker at least once per week.
1. Remove the ice basket, add water and detergent into the water reservoir, then
hold and press “Clean” key for about 3 seconds, the “ ” indicator lights up and
the appliance enters into the cleaning mode.
2. After cleaning for 8 minutes, the appliance stops working and the “ ” indica-
tor flashes.
3. Remove the drain tube at the back of the appliance and place it at the dirty
water outlet. Open the drain plug, and then the dirty water is drained from the
drain tube until all the water inside the appliance is drained out.
4. Close the drain plug and fill the water reservoir with water. And then press
“Clean” key again, the “ ” indicator lights up and the appliance enters into the
cleaning mode.
5. Repeat the operation of step 3 after the detergent inside the appliance is
removed.
6. Clean the inside of appliance with a piece of soft cloth soaked with warm water
and vinegar.
7. Rinse the drain tube and place the drain plug at the fixing groove at the back of
appliance.
8. Wash the ice basket and ice scoop in warm soapy water. Rinse and dry.

9. Clean the exterior of the ice maker with a soft damp cloth. Use a mild
dishwashing soap, if necessary.
NOTE: Do not use organic solvent, boiled water, detergent, strong acid and strong
alkali etc. for cleaning.
NOTE: Please empty the water reservoir and dry it for storage if the ice maker is
not used for a long time.
Drain plug
Drain tube
1/4 PE tube
( Fig.3 )

Flashes
Lights up
Lights solidly
Flashes
1.Be lack of water.
2.The water screen at the
bottom of water reservoir is
blocked.
3.Pump malfunction.
4.There is foreign objects
blocked the float of water
reservoir.
1.Ice basket is full.
2.Malfunction of infrared ray.
The ice-making assembly is
defrosting.
1.Stop making ice, refill water
and then press “ON/OFF” key to
restart ice-making cycle.
2.Remove the water screen at
the bottom for cleaning.
3.Send it to the authorized
department for repair.
4.Check the foreign objects
and restart the appliance.
1.Remove the ice from ice
basket and then press
“ON/OFF” key to restart the
ice-making cycle.
2.The sensor is damaged,
please send it to the autho-
rized department for repair.
No need to deal with it, the
appliance will deal with it
automatically, and it will return
to normal operation after
about 30-45 minutes. Alterna-
tively, you can hold and press
the "Clean" key for 3 seconds,
and then press the "ON /OFF"
key again to restart the
appliance after the cleaning
procedure is finished.

Lights solidly
Flashes
1.Be lack of water.
2.The water screen at the
bottom of water reservoir is
blocked.
3.Pump malfunction.
4.There is foreign objects
blocked the float of water
reservoir.
1.Leave a 15cm clearance on all
sides of the ice maker for
proper ventilation.
2.Fill the water reservoir with
water ranges between 8℃and
28℃
3.Operate the ice maker at a
environment with an ambient
temperature between 10℃
and 32℃.
4.Call customer service.
Poor ice-making
result. The
ice-making process
is normal but the
ice produced is
broken, which lasts
for more than 2
hours.
The ice-making assembly is
frozen.
No need to deal with it. Under
this condition, let the appliance
be defrosted automatically for
about 20 minutes, at that time,
the press keys can not be
operated. The appliance can be
used again after the defrosting
is finished. If this problem
occurs repeatedly, it can be
considered as refrigerant
leakage. Please send the
appliance to the authorized
department for maintenance.

Model:
Applicable climate:
Class:
Power source:
Rated current:
Rated Power:
Refrigerant/Refrigerant amount:
Foaming agent:
Net weight:
Gross weight:
Water inlet mode:
Water Storage Capacity:
Product Size:
Package Size:
IM1102-UL
ST/SN/N
I
120V/60Hz
3.0A
170W
R600a / 0.71oz
C5H10
34.2lbs
39.7lbs
Half-auto
2.7L(0.72gal)
L 19.2’’* W 9.7’’*H16.93’’
L 20.67’’*W12.76’’*H19.73’’
15

16

visit: www.freezimer.com
freezimer
17



www.freezimer.com
freezimerclub

,




www.freezimer.com