Fresca FFT3001CH User manual

INSTALLATION
INSTRUCTIONS
Single-lever faucet
Cleaning
Before use: Unscrew the Aerator and allow the water to run freely for 5 minutes. Then screw the filter back in place.
Periodically: Unscrew the Aerator and remove. Rinse it with running water until any loose debris is cleared. Then replace the Aerator
and tighten.
Aerator
Maintainance
We do NOT recommend you use any household cleaners to clean the product. Because these cleaners change substance or formula
too frequently. The product should always be cleaned only with soapy water and rinsed with clean water and dried with a soft cloth.
FFT3001CH
1
●
We recommend that this product is installed by a qualified professional contractor.
●
Please check this product immediately to ensure that it has not been damaged and is complete.
●
Please flush the water system to ensure that no debris or any other impurities can enter the taps.
Turn off water supply before commencing work .
●Please read these instructions carefully and keep for future reference.
Important

Installation
Dimensions
6.1″
1.6″
6.4″
4.1″
FAUCET
SUPPLY LINES
MALE SCREW
O-RING
RUBBER WASHER
BRASS WASHER
FEMALE SCREW
ALLEN
KEY
FAUCET
CARTRIDGE
RETAINING
NUT
CARTRIDGE
COVER
HANDLE
GRUB
SCREW
CAP
max1.1″
2
Unit:inches
1: Fit the O-ring in the underside of the faucet.
2: Screw the male screw and the supply lines into the faucet
and fully hand tighten.
3: Pass the tail of supply lines through the hole on the basin from above, and place the faucet in position on the basin, to see if any
alteration to the existing supply pipe work is necessary, make any necessary alterations to the pipe work.
4: Tighten the rubber washer, the brass washer with the female screw from the underside of the counter.
5: Check that the faucet is correctly positioned, fully tighten th
e
female screw.
6: Connect the water supply pipes to the tail of supply lines with the hot water and cold water.
This faucet meets or exceeds the following standards:
ASME A112.18.1/CSA B125.1/NSF61-9
This product has been tested and certified by IAPMO. IAPMO LISTED
To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6: Dry and lightly grease the seals (only use silicone grease)