Fresca SEVENA FFT3803 User manual

FFT3803 FRESCA SEVENA INSTALLATION GUIDE PAGE 1
FFT3803
FRESCA SEVENA
INSTALLATION GUIDE
Note: All dimensions and specifications are approximate and subject to change without notice.

4" 4"
1/2"
4.3"
9.1"
1.3" 0.9"
6.1"
5.5"
PAGE 2
1/2"
1.0"
FFT3803 FRESCA SEVENA INSTALLATION GUIDE
4.2"

PAGE 3
lmportant
We recommend that this product be installed by a qualified professional.
Please check this product immediately to ensure that it has not been damaged and there are no
missing pieces.
We recommend that the water system is flushed to ensure that no debris or any other impurities
can enter the taps.
Please read these instructions carefully and keep for future reference.
Maintainance
We do NOT recommend the use of any household cleaners to clean the product because such
cleaners contains harsh chemicals that can damage the finish and/or functions of this product.
The product should always be cleaned with soapy water, rinsed with clean water, and dried with
a soft cloth.
Installation
1. Turn off hot and cold water supply valve before commencing work.
2. Fit the rubber washer into the bottom groove of the faucet, then place the faucet into the
installing hole on the countertop.
3. Place the O-Ring and fixing nut under the countertop and tighten the fixing nut in clockwise
direction.
4. Check that the spout is correctly positioned and then tighten the screws on the fixing nut.
5. Screw the three way connector (making sure the plate washer is inside) onto the bottom
thread of the spout.
6. Install hot switch valve and cold switch valve into the designated holes on the countertop.
Turn the hot switch valve in clockwise direction and cold switch valve in anticlockwise
direction to off state to check for proper placement.
7. Place the plate washer and fixing nut under the countertop and rotate the fixing nut
clockwise to secure each switch valve to the countertop.
8. Adjust the position of the two switch valves if needed by removing cap on each switch valve
grub screw.
9. Screw one end of the supply lines to the threads on each of the hot and cold switch valve.
(See diagram on Page 2).
10. Screw the other end of the supply lines to the thread on the three-way connector.
(See diagram on Page 2).
11. Attach supply line from each switch valve on to hot and cold water supply.
12. Turn on hot and cold water supply valve and check for any leaks.
FFT3803 FRESCA SEVENA INSTALLATION GUIDE

PAGE 4
Fixing nut
O-ring
Three-way
connector
Fixing nut
Fixing
nut
Fixing nut
Fixing nut
Spout
Hot switch valve
Cold switch valve
Valve assembly
Valve
assembly
Grub screw
Cap
Allen key
Plate washer
Cartridge
Valve body
Valve assembly
Supply Line
Aerator
FFT3803 FRESCA SEVENA INSTALLATION GUIDE