Freshtel Netcomm V100 Quick guide

Netcomm V100
Configuration Instructions
Step 1: Connect your V100
1. Phone – plug in your analog telephone cord.
2. Ethernet Port - use an Ethernet cable to connect your V100 to your router or modem.
3. Power connection - Connect the power to your V100.
4. See your Netcomm V100 User Manual for more connection options.
Step 2: Install the V100 Software Utility.
1. If you have not already done so, install the V100 PC Tool utility on your PC. This would
have come on a CD with your V100, and can also be downloaded from the Netcomm
website:
http://www.netcomm.com.au/Support/downloads.php?Category=VoIP&Products=V100
2. Run the V100 PC Tools Application

Step 3: Configure the V100 ATA
1. You will need to know your Firefly Number and Password.
2. Click on the SIP tab, then select the Local tab from the below row. Set it up as follows
(be sure to use your own Firefly Number and password!):
3. Click on the Apply button.
4. Click on the Close button.
5. Your Netcomm V100 is now configured and ready to use the Firefly Network. Simply
pick up the phone and dial!
Dialling:
To dial a PSTN number, dial like you would with a normal phone. Eg 61390000000
To dial a Firefly number or voicemail, prefix a star to the number. Eg *80001234, *123